Home › Suspension › SUSPENSION CONTROL › ABSORBER CONTROL ACTUATOR
RM27L0U _53 Suspension _049315 SUSPENSION CONTROL _0235710 ABSORBER CONTROL ACTUATOR G

SUSPENSION CONTROL  ABSORBER CONTROL ACTUATOR  INSPECTION  


PROCEDURE

Hide 89241B 1.INSPECT ABSORBER CONTROL ACTUATOR

C179520E02
0.069,0 2.628,0.351 2.560,0.351 10 Component without harness connected: (Front Absorber Control Actuator LH) 0.587,1.594 1.035,1.778 0.448,0.184 10 FBL+ 2.46,1.589 2.977,1.773 0.517,0.184 10 FBL- 1.923,1.431 2.416,1.668 false 1.551,1.448 1.094,1.656 false 0.587,0.998 1.035,1.182 0.448,0.184 10 FAL+ 2.46,1.022 2.977,1.205 0.517,0.184 10 FAL- 1.923,1.25 2.416,1.101 false 1.551,1.267 1.094,1.094 false

a.

Inspect the absorber control actuator LH.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Sensor Condition Specified Condition
1 (FAL+) - 2 (FAL-) Always 6.4 to 7.2 Ω
3 (FBL-) - 4 (FBL+) Always 6.4 to 7.2 Ω



c.
C179520E01
0.069,0 2.628,0.351 2.560,0.351 10 Component without harness connected: (Front Absorber Control Actuator RH) 0.587,1.594 1.035,1.778 0.448,0.184 10 FBR+ 2.46,1.589 2.977,1.773 0.517,0.184 10 FBR- 1.923,1.431 2.416,1.668 false 1.551,1.448 1.094,1.656 false 0.587,0.998 1.035,1.182 0.448,0.184 10 FAR+ 2.46,1.022 2.977,1.205 0.517,0.184 10 FAR- 1.923,1.25 2.416,1.101 false 1.551,1.267 1.094,1.094 false

Inspect the absorber control actuator RH.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Sensor Condition Specified Condition
1 (FAR+) - 2 (FAR-) Always 6.4 to 7.2 Ω
3 (FBR-) - 4 (FBLR+) Always 6.4 to 7.2 Ω