CHECK DTC
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Read the DTCs following the prompts on the Techstream screen. Enter the following menus: Chassis / Air suspension / Trouble Codes.
Check the details of the DTCs (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
CLEAR DTC
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Operate the Techstream to clear the codes. Enter the following menus: Chassis / Air suspension / Trouble Codes.
According to the display on the Techstream, select the trouble code data display with the clear button.