Home › Suspension › SUSPENSION CONTROL › HEIGHT CONTROL SWITCH
RM27L0U _53 Suspension _049315 SUSPENSION CONTROL _0235713 HEIGHT CONTROL SWITCH G

SUSPENSION CONTROL  HEIGHT CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 89249 1.INSPECT HEIGHT CONTROL SWITCH (NO. 1 ABSORBER CONTROL SWITCH)

a.
C271459E01
1.748,1.253 1.748,0.45 1.748,0.45 1.485,0.45 false 1.06,0.37 1.414,0.515 0.354,0.145 10 LSW 1.816,1.77 2.169,1.915 0.354,0.145 10 HSW 1.588,1.361 1.588,1.857 1.588,1.857 1.766,1.857 false 0.116,0.101 0.323,0.282 0.207,0.181 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (LSW) - 6 (E) "Down" pressed Below 1 Ω
Not pressed 10 KΩ or higher
5 (HSW) - 6 (E) "Up" pressed Below 1 Ω
Not pressed 10 KΩ or higher


Text in Illustration
*a Component without harness connected
(Height Control Switch)

If the result is not as specified, replace the height control switch (No. 1 absorber control switch).


Hide 89249D 2.INSPECT HEIGHT CONTROL MODE SELECT SWITCH (NO. 2 ABSORBER CONTROL SWITCH)

a.
C271458E01
0.119,0.02 0.310,0.211 0.191,0.191 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 - 6 Pressed Below 1 Ω
Not pressed 10 KΩ or higher


Text in Illustration
*a Component without harness connected
(Height Control Mode Select Switch)

If the result is not as specified, replace the height control mode select switch (No. 2 absorber control switch).