Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER
RM27L0U _53 Suspension _049317 FRONT SUSPENSION _0235716 FRONT SHOCK ABSORBER N

FRONT SUSPENSION  FRONT SHOCK ABSORBER  DISPOSAL  


PROCEDURE

Hide 48520 1.DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH

a.

Fully extend the shock absorber rod.


b.
C181278E01
0.977,1.38 1.196,1.545 0.219,0.165 10 A 1.738,1.371 1.922,1.554 0.183,0.183 10 B

Using a drill, make a hole in the cylinder between A and B shown in the illustration to discharge the gas inside.

CAUTION:
·

Be careful when drilling because shards of metal may fly about. Always use the proper safety equipment.

·

For off road type shock absorbers, be extremely careful when drilling it as the gas pressure is much higher than the standard type.



NOTICE:

The gas is colorless, odorless and nonpoisonous.