Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER
RM27L0U _53 Suspension _049317 FRONT SUSPENSION _0235716 FRONT SHOCK ABSORBER A

FRONT SUSPENSION  FRONT SHOCK ABSORBER  INSTALLATION  


PROCEDURE

Hide 1.TEMPORARILY INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING

a.

Temporarily install the upper side of the shock absorber to the chassis frame with the 4 nuts.


b.

Temporarily install the lower side of the shock absorber to the lower suspension arm with the bolt, washer and nut.


Hide 2.STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Press down on the vehicle several times to stabilize the suspension.


Hide 3.TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING

a.

Tighten the nut.

Torque:
195 N*m (1988 kgf*cm, 144 ft.*lbf)


b.
C163294E01
1.369,1.39 1.580,1.546 0.211,0.156 10 1,5 1.979,0.563 2.079,0.708 0.100,0.145 10 2 1.97,1.39 2.071,1.532 0.100,0.142 10 3 1.317,0.586 1.421,0.732 0.104,0.145 10 4

Tighten the 4 upper nuts in diametrically opposite pairs.

Torque:
45 N*m (459 kgf*cm, 33 ft.*lbf)


c.

Check that the first nut that was tightened is at the torque specification.


Hide 89269A 4.INSTALL SUSPENSION CONTROL BRACKET (w/ Air Suspension)

a.

Install the suspension control bracket with the nut.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


Hide 89241B 5.INSTALL ABSORBER CONTROL ACTUATOR (w/ Air Suspension)

Hide 6.INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)