1.REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING LH
89516
2.DISCONNECT SKID CONTROL SENSOR WIRE
Remove the 2 bolts and disconnect the sensor wire from the steering knuckle and suspension upper arm.
43212
3.DISCONNECT STEERING KNUCKLE LH
Support the front suspension lower arm LH with a jack.
Remove the clip and the nut.
Using SST, disconnect the upper ball joint from the steering knuckle.
53737B
4.REMOVE FRONT FENDER APRON SEAL LH
Using a clip remover, remove the 6 clips and apron seal.
53739A
5.REMOVE FRONT FENDER APRON SEAL REAR LH
Using a clip remover, remove the 5 clips and apron seal.
48630
6.REMOVE FRONT SUSPENSION UPPER ARM ASSEMBLY
Remove the nut, bolt, 2 washers and suspension upper arm.