Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM
RM27L0U _53 Suspension _049317 FRONT SUSPENSION _0235718 FRONT LOWER SUSPENSION ARM A

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM  REASSEMBLY  


PROCEDURE

Hide 48331E 1.INSTALL FRONT NO. 1 SPRING BUMPER LH

a.

Install the No. 1 spring bumper to the vehicle.

Torque:
31 N*m (316 kgf*cm, 23 ft.*lbf)


Hide 48655E 2.INSTALL FRONT NO. 2 LOWER ARM LH

C353479E01
0.552,1.625 0.833,1.625 false 1.406,2.229 1.573,2.01 false 2.938,4.042 2.438,4.229 2.438,4.229 2.917,3.594 false 0.24,1.542 0.698,1.74 0.458,0.198 10 false SST 1.031,4.302 2.854,4.521 1.823,0.219 10 false Bush Positioning Protrusion 1.583,1.854 2.042,2.052 0.458,0.198 10 false SST

a.

Using SST and a press, press in a new bush.

SST
09710-26011  (09710-05081)

NOTICE:

Press the bush while making sure the bush positioning protrusions are perpendicular to the lower arm, as shown in the illustration.



Hide 48654F 3.INSTALL FRONT NO. 1 LOWER ARM BUSH LH

C155984E01
0.099,0.888 0.408,1.036 0.309,0.148 10 SST 0.461,0.975 0.727,0.975 false 0.753,1.946 0.461,0.975 false

a.

Using SST and a press, press in a new bush.

SST
09223-00010  
09612-30012  


Hide 48626 4.INSTALL FRONT LOWER BALL JOINT ATTACHMENT LH

a.

Install the attachment with the nut and a new cotter pin.

Torque:
167 N*m (1703 kgf*cm, 123 ft.*lbf)

NOTICE:

If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.