Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR
RM27L0U _53 Suspension _049317 FRONT SUSPENSION _0235719 FRONT STABILIZER BAR G

FRONT SUSPENSION  FRONT STABILIZER BAR  INSPECTION  


PROCEDURE

Hide 48810 1.INSPECT FRONT STABILIZER LINK ASSEMBLY LH

C124387

a.

Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.


b.

Use a torque wrench to turn the nut continuously at a rate of 2 to 3 seconds per turn. Take the torque reading on the fifth turn.

·

Standard turning torque


Torque:
0.5 to 3.4 N*m (5.1 to 36 kgf*cm, 4.4 to 30 in.*lbf)

If the value is not within the specified range, replace the front suspension toe control link with a new one.



c.

Check the dust boot for cracks or grease leakage.