Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR
RM27L0U _53 Suspension _049318 REAR SUSPENSION _0235726 REAR STABILIZER BAR G

REAR SUSPENSION  REAR STABILIZER BAR  INSPECTION  


PROCEDURE

Hide 48840A 1.INSPECT REAR STABILIZER LINK ASSEMBLY LH

C124387

a.

Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.


b.

Use a torque wrench to turn the nut continuously at a rate of 2 to 3 seconds per turn. Take the torque reading on the fifth turn.

Torque:
0.05 to 1.96 N*m (0.51 to 20.0 kgf*cm, 4.51 to 17.3 in.*lbf)

If the value is not within the specified range, replace the front suspension toe control link with a new one.


c.

Check the dust boot for cracks or grease leakage.