Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM
RM27L0U _53 Suspension _049319 TIRE PRESSURE MONITORING _0235729 TIRE PRESSURE WARNING SYSTEM U

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  TERMINALS OF ECU  


HINT:

Inspect the connectors from the back side.


CHECK TIRE PRESSURE WARNING ECU


U153947E02
2.167,0.854 2.438,1.021 0.271,0.167 10 false H40

a.

Disconnect the O14 tire pressure warning antenna and receiver connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage
Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
H40-12 (RDA) - H40-9 (GND) G - W-B Tire pressure warning antenna and receiver signal Ignition switch ON 11 to 14 V


c.

Connect the O14 tire pressure warning antenna and receiver connector.


d.

Measure the voltage and resistance according to the value(s) in the table below.

Standard
Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
H40-1 (CLSW) - H40-9 (GND) B - W-B Tire pressure warning reset switch Ignition switch ON
Tire pressure warning reset switch OFF
8 to 14 V
Ignition switch ON
Tire pressure warning reset switch ON
Below 1.5 V
H40-2 (SPD) - H40-9 (GND) V - W-B Vehicle speed signal Vehicle is running Pulse generation
(see waveform 1)
H40-3 (TC) - H40-9 (GND) W - W-B TC terminal When terminal TC is not connected 8 to 14 V
H40-5 (IND) - H40-9 (GND) LG - W-B Tire pressure warning light output signal After ignition switch is turned ON, when tire pressure warning light illuminates for 3 seconds 2.2 to 4.4 V
Ignition switch ON
Tire pressure warning light off
Below 0.5 V
H40-6 (RF5V) - H40-9 (GND) Y - W-B Tire pressure warning antenna and receiver power source Ignition switch ON 11 to 14 V
H40-7 (IG) - H40-9 (GND) Y - W-B IG power source Ignition switch ON 11 to 14 V
H40-9 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω
H40-10 (SIL) - H40-9 (GND) L - W-B Diagnosis tester communication line Ignition switch ON, when communication is not performed with a tester 8 to 14 V
H40-11 (GND2) - H40-9 (GND) P - W-B Tire pressure warning antenna and receiver ground Always Below 1 Ω

If the result is not as specified, the ECU may have a malfunction.


e.
F047507E23
3.021,1.417 3.354,1.615 0.333,0.198 10 false GND

Using an oscilloscope, check the waveform 1.

Item Content
Terminal No. (Symbol) H40-2 (SPD) - H40-9 (GND)
Tool Setting 5 V/DIV., 200 ms/DIV.
Vehicle Condition While driving at approximately 20 km/h (12 mph).