Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM
RM27L0U _53 Suspension _049319 TIRE PRESSURE MONITORING _0235729 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2176/76  Receiver Error  


DESCRIPTION

The signals are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU.

DTC Code DTC Detection Condition Trouble Area
C2176/76 Malfunction in the tire pressure warning ECU internal circuit. Tire pressure warning ECU

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.

·

It is necessary to perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.



PROCEDURE

1.CLEAR DTC
a.

Turn the ignition switch off.


b.

Connect the Techstream to the DLC3.


c.

Turn the ignition switch to ON and turn the Techstream on.


d.

Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.


e.

Clear the DTCs.



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
HINT:

After clearing DTCs, turn the ignition switch off and ON once.


a.

Turn the ignition switch off.


b.

Connect the Techstream to the DLC3.


c.

Turn the ignition switch to ON and turn the Techstream on.


d.

Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.


e.

Check for DTCs.

Result
Result Proceed to
DTC C2176/76 is not output. A
DTC C2176/76 is output again. B



A

B

REPLACE TIRE PRESSURE WARNING ECU