Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM
RM27L0U _53 Suspension _049319 TIRE PRESSURE MONITORING _0235729 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2177/77  Initialization not Completed  


DESCRIPTION

Initialization is necessary if one of the following occurs: 1) the ECU is replaced; 2) the tire pressure warning valve and transmitter is replaced; 3) tires with a different tire standard pressure are installed; 4) the tires are rotated on vehicles whose front and rear tire inflation pressure standard values are different; or 5) a new vehicle is delivered.

DTC Code DTC Detection Condition Trouble Area
C2177/77 When all conditions below are met:
·

During initialization

·

Signal is not received from tire pressure warning valve and transmitter for 20 minutes or more

·

Vehicle speed is more than 8 km/h (5 mph) for a total of 20 minutes


·

Tire pressure warning valve and transmitter

·

Tire pressure warning antenna and receiver

·

Tire pressure warning ECU

·

Harness or connector



WIRING DIAGRAM

C158876E15
2.052,1.948 4.906,2.438 2.854,0.49 10 false Front Tire Pressure Warning Valve and Transmitter RH 4.031,0.615 4.333,0.802 0.302,0.188 10 false +5V 4,0.938 4.375,1.104 0.375,0.167 10 false RDA 4,1.323 4.354,1.479 0.354,0.156 10 false GND 0.396,0.552 0.708,0.74 0.313,0.188 10 false O14 0.406,0.719 3.281,0.906 2.875,0.188 10 false Tire Pressure Warning Antenna and Receiver 2.031,2.833 4.885,3.323 2.854,0.49 10 false Front Tire Pressure Warning Valve and Transmitter LH 2.042,3.74 4.896,4.229 2.854,0.49 10 false Rear Tire Pressure Warning Valve and Transmitter RH 2.021,4.625 4.875,5.115 2.854,0.49 10 false Rear Tire Pressure Warning Valve and Transmitter LH 1.302,6.083 1.615,6.281 0.313,0.198 10 false H52 1.302,6.25 3.667,6.479 2.365,0.229 10 false Tire Pressure Warning Reset Switch 1.01,8.229 1.99,8.438 0.979,0.208 10 false : Radio Signal 5.281,7.615 5.573,7.781 0.292,0.167 10 false H40 5.281,7.781 7.052,8.021 1.771,0.24 10 false Tire Pressure Warning ECU 6.031,6.906 6.552,7.167 0.521,0.26 10 false GND 6.031,5.677 6.552,5.875 0.521,0.198 10 false CLSW 5.74,5.563 5.917,5.76 0.177,0.198 10 false 1 5.74,6.792 5.927,6.99 0.188,0.198 10 false 9 6.031,0.604 6.615,0.844 0.583,0.24 10 false RF5V 6.031,0.938 6.76,1.198 0.729,0.26 10 false RDA 6.021,1.302 6.583,1.573 0.563,0.271 10 false GND2 5.74,0.479 5.927,0.677 0.188,0.198 10 false 6 5.698,0.833 5.969,1.021 0.271,0.188 10 false 12 5.698,1.198 5.896,1.396 0.198,0.198 10 false 11 4.49,1.198 4.729,1.396 0.24,0.198 10 false 4 4.479,0.823 4.646,1.021 0.167,0.198 10 false 1 4.49,0.479 4.719,0.635 0.229,0.156 10 false 5 2.25,5.552 2.469,5.75 0.219,0.198 10 false 1 1.156,5.563 1.271,5.813 0.115,0.25 10 false 2

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.

·

It is necessary to perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU after the ECU and/or valve and transmitter has been replaced.



PROCEDURE

1.CHECK FREQUENCY RECEIVING CONDITION
a.

Check if the vehicle is in conditions such as the ones described below:

i.

Facilities or devices that use similar radio frequencies are located in the vicinity of the vehicle.

HINT:

If the vehicle is located in areas described above, the tire pressure warning light may blink for a minute and turn on in a particular area.



ii.

Devices using similar radio frequencies are used in the vehicle.

OK:

Facilities, or devices that use similar radio frequencies are not located in the vicinity of the vehicle.


HINT:

Radio frequency may be interrupted due to surroundings or devices installed by the user.





OK

2.PERFORM INITIALIZATION

NG

CHECK IF ANY DEVICE IS INSTALLED BY USER

2.PERFORM INITIALIZATION

NEXT

3.CONFIRM TIRE INFLATION PRESSURE (DATA LIST)
3.CONFIRM TIRE INFLATION PRESSURE (DATA LIST)
a.

Turn the ignition switch off.


b.

Connect the Techstream to the DLC3.


c.

Turn the ignition switch to ON and turn the Techstream on.


d.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.


e.

Check the values by referring to the table below.

Tire Pressure Monitor
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
ID 1 Tire Inflation Pressure ID1 tire inflation pressure /
min.: Absolute pressure / 100.00 kPa (1 kgf/cm2, 14 psi), Relative pressure / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure / 449.35 kPa (4.6 kgf/cm2, 65 psi), Relative pressure / 349.35 kPa (3.6 kgf/cm2, 51 psi)
Actual tire inflation pressure If 100 kPa (1 kgf/cm2, 14 psi) is displayed for absolute pressure or 0 kPa (0 kgf/cm2, 0 psi) is displayed for relative pressure, data has not been received*.
ID 2 Tire Inflation Pressure ID2 tire inflation pressure /
min.: Absolute pressure / 100.00 kPa (1 kgf/cm2, 14 psi), Relative pressure / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure / 449.35 kPa (4.6 kgf/cm2, 65 psi), Relative pressure / 349.35 kPa (3.6 kgf/cm2, 51 psi)
Actual tire inflation pressure If 100 kPa (1 kgf/cm2, 14 psi) is displayed for absolute pressure or 0 kPa (0 kgf/cm2, 0 psi) is displayed for relative pressure, data has not been received*.
ID 3 Tire Inflation Pressure ID3 tire inflation pressure /
min.: Absolute pressure / 100.00 kPa (1 kgf/cm2, 14 psi), Relative pressure / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure / 449.35 kPa (4.6 kgf/cm2, 65 psi), Relative pressure / 349.35 kPa (3.6 kgf/cm2, 51 psi)
Actual tire inflation pressure If 100 kPa (1 kgf/cm2, 14 psi) is displayed for absolute pressure or 0 kPa (0 kgf/cm2, 0 psi) is displayed for relative pressure, data has not been received*.
ID 4 Tire Inflation Pressure ID4 tire inflation pressure /
min.: Absolute pressure / 100.00 kPa (1 kgf/cm2, 14 psi), Relative pressure / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure / 449.35 kPa (4.6 kgf/cm2, 65 psi), Relative pressure / 349.35 kPa (3.6 kgf/cm2, 51 psi)
Actual tire inflation pressure If 100 kPa (1 kgf/cm2, 14 psi) is displayed for absolute pressure or 0 kPa (0 kgf/cm2, 0 psi) is displayed for relative pressure, data has not been received*.

HINT:
·

*: It may take about 5 to 6 minutes until the values are displayed.

·

When no "ID Tire Inflation Pressure" has changed, rotate the tire 90 to 270°. Then recheck it.



Result
Result proceed to
Tire pressure values are not displayed A
All tire pressure readings are equal to specified values B



A

GO TO C2121/21 to C2124/24 FLOWCHART

B

END