Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER
RM27L0U _54 Brake _049322 BRAKE SYSTEM (OTHER) _0235746 BRAKE MASTER CYLINDER A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER  INSTALLATION  


PROCEDURE

Hide 47201 1.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

Install a new brake master cylinder seal onto the brake master cylinder.


b.
C154471

Install the brake master cylinder with 2 new nuts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


Hide 47311 2.CONNECT FRONT NO. 1 BRAKE TUBE

a.
C208549E01
1.917,0.917 2.052,1.073 0.135,0.156 10 true A 1.833,1.813 1.979,2 0.146,0.188 10 true B

Using a union nut wrench, connect the brake tube (labeled A) to the brake master cylinder.

Torque:
20 N*m (199 kgf*cm, 14 ft.*lbf)

NOTICE:

Use the formula to calculate special torque vales for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 47321 3.CONNECT REAR NO. 1 BRAKE TUBE

a.

Using a union nut wrench, connect the brake tube (labeled B) to the brake master cylinder.

Torque:
20 N*m (199 kgf*cm, 14 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 4.CONNECT BRAKE FLUID LEVEL WARNING SWITCH CONNECTOR

a.
C154470

Connect the brake fluid level warning switch connector.