Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER
RM27L0U _54 Brake _049322 BRAKE SYSTEM (OTHER) _0235747 BRAKE BOOSTER G

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 44610 1.INSPECT BRAKE BOOSTER

C123869

a.

OPERATING CHECK

i.

Depress the brake pedal several times with the engine off and check that there is no change in the pedal reserve distance.


ii.

Depress the brake pedal and start the engine. If the pedal goes down slightly, operation is normal.



b.
C123870E04
0.495,1.672 0.730,1.830 0.235,0.158 10 1st 0.868,1.58 1.144,1.738 0.276,0.158 10 2nd 1.195,1.345 1.444,1.503 0.248,0.158 10 3rd 0.213,0.028 0.956,0.191 0.743,0.163 10 CORRECT 1.975,0.028 2.866,0.208 0.891,0.180 10 INCORRECT

AIRTIGHTNESS CHECK

i.

Start the engine and stop it after 1 or 2 minutes. Depress the brake pedal several times slowly.

If the pedal goes down farthest the 1st time, but gradually rises after the 2nd or 3rd time, the booster is airtight.


ii.

Depress the brake pedal while the engine is running, and stop the engine with the pedal depressed. If there is no change in the pedal reserve travel after holding the pedal for 30 seconds, the booster is airtight.



Hide 44730 2.CHECK BRAKE VACUUM CHECK VALVE ASSEMBLY

a.

Check the check valve.

i.

Slide the clip and disconnect the vacuum hose.


ii.

Remove the check valve from the booster.


iii.
C155487E01
0.64,0.011 1.333,0.177 0.693,0.165 10 Ventilation 2.001,0.028 2.916,0.193 0.915,0.165 10 No Ventilation

Check that there is ventilation from the booster to the engine, and no ventilation from the engine to the booster.

If the results are not as specified, replace the check valve assembly.