Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM27L0U _54 Brake _049323 BRAKE (FRONT) _0235751 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  INSTALLATION  


PROCEDURE

Hide 43512 1.INSTALL FRONT DISC

a.
C155464E03
1.76,1.177 2.531,0.938 2.531,0.938 1.781,1.104 false 2.594,0.865 3.344,1.146 0.75,0.281 10 true Matchmark

Align the matchmarks, and then install the front disc.

HINT:

When replacing the front disc with a new one, select the installation position where the front disc has the smallest runout.



Hide 2.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH

a.
C154478

Install the disc brake caliper with 2 new bolts.

Torque:
180 N*m (1835 kgf*cm, 133 ft.*lbf)


Hide 47317 3.CONNECT NO. 7 FRONT BRAKE TUBE

a.
C242481

Using a union nut wrench, connect the front brake tube.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 04465 4.INSTALL FRONT DISC BRAKE PAD KIT

a.
C155459E02
0.616,2.964 1.823,3.129 1.207,0.165 10 Disc brake grease 0.942,2.485 1.932,2.660 0.989,0.174 10 Disc Brake Pad 1.101,0.307 2.554,0.481 1.452,0.174 10 No. 2 Anti-squeal Shim 1.607,0.657 3.059,0.831 1.452,0.174 10 No. 1 Anti-squeal Shim 0.5,0.403 1.054,0.403 false 1.007,0.742 1.578,0.742 false 1.47,1.811 1.47,2.465 false 1.944,2.165 1.944,2.322 1.944,2.322 1.47,2.322 false

Apply disc brake grease to both sides of the No. 1 anti-squeal shims.


b.

Install the No. 1 and No. 2 anti-squeal shims to each pad.


c.
C155460

Install the 2 pads to the disc brake caliper.


d.
C155461

Install the front disc brake anti-rattle spring between the 2 pads.

NOTICE:

The anti-rattle spring can be used again if it has sufficient rebound; no deformation, cracks or wear; and has had all rust, dirt and foreign matter cleaned off.



e.
C154476

Install the 2 hole pins.


f.

Install the pin hold clip.

NOTICE:

The pin hold clip can be used again if it has sufficient rebound; no deformation or wear; and has had all rust, dirt and foreign matter cleaned off.



Hide 42603 6.INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)