Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM27L0U _54 Brake _049323 BRAKE (FRONT) _0235751 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE CYLINDER BOOT

a.
C201387

Using a screwdriver, remove the 4 set rings and 4 cylinder boots from the disc brake caliper.

HINT:

Tape the screwdriver tip before use.



Hide 47731 2.REMOVE FRONT DISC BRAKE PISTON

a.
C154480

Install one side of the disc brake pad.


b.

Install a wooden plate between the pistons of the disc brake caliper to prevent the pistons from jumping out.


c.

Using an air gun, gradually apply compressed air and remove the 2 disc brake pistons from the cylinder.

CAUTION:

Do not place your fingers in front of the pistons when using compressed air.



d.

Remove the brake pad and wooden plate.


e.

Temporarily install the 2 disc brake pistons that were removed. Then install the disc brake pad to the side in which the 2 disc brake pistons were temporarily installed.


f.

Install a wooden plate between the pistons of the disc brake caliper to prevent the pistons from jumping out.


g.

Using an air gun, gradually apply compressed air and remove the 2 disc brake pistons from the other side of the cylinder.


h.

Remove the 2 disc brake pistons which were temporarily installed.


Hide 3.REMOVE PISTON SEAL

a.
C201386

Using a screwdriver, remove the 4 piston seals from the disc brake caliper.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Do not damage the inner cylinder or cylinder groove.



Hide 31478B 4.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP

Hide 47547B 5.REMOVE FRONT DISC BRAKE BLEEDER PLUG