Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM27L0U _54 Brake _049323 BRAKE (FRONT) _0235751 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  REASSEMBLY  


PROCEDURE

Hide 47547B 1.TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG

a.

Temporarily install the bleeder plug to the disc brake caliper.

HINT:

The bleeder plug will be tightened to the torque specification in the "BLEED AIR FROM BRAKE LINE" procedure.



Hide 31478B 2.INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP

Hide 3.INSTALL PISTON SEAL

a.
C191833E01
0.763,2.863 2.787,3.047 2.024,0.184 10 Lithium soap base glycol grease

Apply a light coat of lithium soap base glycol grease to the entire inner and outer circumference of 4 new piston seals.


b.

Install the 4 piston seals to the disc brake caliper.


Hide 47731 4.INSTALL FRONT DISC BRAKE PISTON

a.
C191834E03
0.802,2.042 0.802,2.396 true 1.344,0.552 2.021,0.552 true 0.75,2.938 2.802,3.271 2.052,0.333 10 false Lithium soap base glycol grease 0.583,2.406 1.021,2.563 0.438,0.156 10 false Piston 2.052,0.479 2.938,0.802 0.885,0.323 10 false Cylinder Boot

Apply a light coat of lithium soap base glycol grease to the entire inner circumference of 4 new cylinder boots.


b.

Apply a light coat of lithium soap base glycol grease to the entire outer circumference of the 4 front disc brake pistons where they contact the cylinder boots and front disc brake caliper.


c.

Install the 4 cylinder boots to the 4 front disc brake pistons.

NOTICE:

Do not forcibly install the piston into the disc brake caliper.



d.

Install the 4 front disc brake pistons to the front disc brake caliper.


Hide 5.INSTALL CYLINDER BOOT

a.
C155456E05
0.979,0.792 0.979,0.146 0.979,0.146 1.188,0.146 false 0.802,1.01 0.385,1.01 0.385,1.01 0.385,2.302 true 1.25,0.073 2.198,0.396 0.948,0.323 10 false Cylinder Boot 0.115,2.323 0.677,2.708 0.563,0.385 10 false Set Ring

Install one side of each of the 4 cylinder boots to the front disc brake caliper.

NOTICE:
·

Install the cylinder boot securely into the grooves of the cylinder and piston.

·

Do not damage the cylinder boot.




b.

Install the 4 set rings.