Home › Brake › BRAKE (REAR) › REAR BRAKE
RM27L0U _54 Brake _049324 BRAKE (REAR) _0235752 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  REMOVAL  


PROCEDURE

Hide 42603 1.REMOVE REAR WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Wash brake fluid off immediately if it is spilled on any painted surface.


Hide 47319F 3.DISCONNECT REAR FLEXIBLE HOSE LH

a.
C180573

Remove the union bolt and gasket, and then disconnect the flexible hose from the rear disc brake cylinder. Use a container to catch brake fluid as it drains out.


Hide 4.REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH

a.
C180572

Remove the 2 slide pins.


b.

Remove the cylinder from the rear disc brake cylinder mounting.


Hide 04466 5.REMOVE REAR DISC BRAKE PAD

a.

Remove the 2 brake pads from the rear disc brake cylinder mounting.


Hide 04946 6.REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM

a.

Remove the anti-squeal shim from each disc brake pad.


Hide 7.REMOVE PAD WEAR INDICATOR PLATE

a.

Remove the pad wear indicator plate from the inner disc brake pad.


Hide 8.REMOVE REAR DISC BRAKE PAD SUPPORT PLATE

NOTICE:
·

The pad support plates are attached to the rear disc brake cylinder mounting with double-sided tape. When removing the brake pads, make sure the pad support plates are not detached.

If the pad support plates are not detached, they can be reused.

If they are detached, replace the pad support plates with new ones.

·

If the pad support plates are removed during maintenance of parts, replace them with new ones.



a.

Remove the 4 pad support plates from the rear disc brake cylinder mounting.


Hide 47722A 9.REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH

a.
C180571

Remove the 2 bolts and rear disc brake cylinder mounting.

NOTICE:

If the pad support plates are removed during maintenance of parts, replace them with new ones.



b.

Remove the 2 rear disc brake bush dust boots from the rear disc brake cylinder mounting.


Hide 42491 10.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 42431 11.REMOVE REAR DISC

a.
C178157E02
1.885,0.917 2.958,0.917 2.958,0.917 2.958,1.594 true 1.927,1 2.125,1.167 2.125,1.167 2.948,1.167 true 2.583,1.615 3.292,1.948 0.708,0.333 10 false Matchmark

Put matchmarks on the rear disc and axle hub if planning to reuse the disc.


b.
C155453

Turn the shoe adjuster until the disc turns freely, and then remove the disc.