Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE
RM27L0U _54 Brake _049324 BRAKE (REAR) _0235753 REAR BRAKE FLEXIBLE HOSE A

BRAKE (REAR)  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


PROCEDURE

Hide 47316A 1.INSTALL REAR BRAKE TUBE FLEXIBLE HOSE

a.
C208574

Install the flexible hose with the 2 bolts.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


b.
C208573

Connect the flexible hose bracket with the bolt.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


c.
C180573

Install the flexible hose and a new gasket to the disc brake cylinder with a new union bolt.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)

HINT:

Install the flexible hose lock securely in the lock hole in the cylinder.



d.
C178154

Set the flexible hose to the connecting point with the brake tube, and then attach a new clip.


e.

Using a union nut wrench, connect the flexible hose tube.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 42603 3.INSTALL REAR WHEEL

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)