ENTER DIAGNOSTIC MODE
w/ Navigation System
Enter diagnostic mode by using the display panel on the navigation receiver assembly (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
w/o Navigation System
Enter diagnostic mode by using the display panel on the radio and display receiver assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR)
Enter diagnostic mode by using the rear switch and volume assembly.
Start the engine.
While pressing and holding the "SETTING" switch on the rear switch and volume assembly, operate the light control switch: Off → Tail → Off → Tail → Off → Tail → Off.
Diagnostic mode starts and the "REAR Check" screen will be displayed.
REAR CHECK
Use the rear switch and volume assembly for each inspection.
This mode checks the color display on the television display assembly.
The television display assembly is not a touch panel type. Do not touch the screen.
Color Bar Check
Select "Color Bar Check" from the "REAR Check" screen.
Select a color bar from the "Color Bar Check" screen.
Check the display color.
The entire screen turns to the color or stripe which is selected.
The screen returns to the "Color Bar Check" screen if the rear switch and volume assembly is operated again.
Remote Commander Check
Select "Remote Commander Check" from the "REAR Check" screen.
Operate each switch and check that the switch name and condition are correctly displayed.