Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049329 AUDIO / VIDEO _0235769 REAR SEAT ENTERTAINMENT SYSTEM J

AUDIO / VIDEO  REAR SEAT ENTERTAINMENT SYSTEM  Sound Signal Circuit between Navigation Receiver Assembly and Television Display Assembly  


DESCRIPTION

The television display assembly sends the sound signal to the navigation receiver assembly through this circuit.

The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, navigation receiver assembly or speakers.

WIRING DIAGRAM

E286165E04
4.26,2.333 4.906,2.51 0.646,0.177 10 false Shielded 2.333,2.333 2.979,2.51 0.646,0.177 10 false Shielded 0.802,0.438 1.104,0.594 0.302,0.156 10 false L1+ 0.813,0.875 1.24,1.031 0.427,0.156 10 false L1- 0.771,1.323 1.198,1.479 0.427,0.156 10 false R1+ 0.802,1.75 1.229,1.906 0.427,0.156 10 false R1- 0.667,2.198 1.094,2.354 0.427,0.156 10 false SLD1 6.156,0.427 6.583,0.583 0.427,0.156 10 false CDL+ 6.156,0.865 6.583,1.021 0.427,0.156 10 false CDL- 5.917,0.354 6.094,0.51 0.177,0.156 10 false 4 5.917,0.781 6.094,0.938 0.177,0.156 10 false 5 5.917,1.229 6.094,1.385 0.177,0.156 10 false 2 5.917,1.656 6.094,1.813 0.177,0.156 10 false 3 1.188,0.333 1.365,0.49 0.177,0.156 10 false 7 1.188,0.781 1.365,0.938 0.177,0.156 10 false 8 1.188,1.219 1.365,1.375 0.177,0.156 10 false 9 1.177,1.667 1.354,1.823 0.177,0.156 10 false 10 1.177,2.083 1.354,2.24 0.177,0.156 10 false 11 0.177,2.51 0.531,2.667 0.354,0.156 10 false U13 0.177,2.667 1.417,3.063 1.24,0.396 10 false Television Display Assembly 5.802,2.688 7.156,3.365 1.354,0.677 10 false Navigation Receiver Assembly 6.156,1.302 6.583,1.458 0.427,0.156 10 false CDR+ 6.156,1.75 6.583,1.906 0.427,0.156 10 false CDR- 5.813,2.521 6.104,2.698 0.292,0.177 10 false I25

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
a.

Disconnect the I25 navigation receiver assembly connector.


b.

Disconnect the U13 television display assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I25-4 (CDL+) - U13-7 (L1+) Always Below 1 Ω
I25-5 (CDL-) - U13-8 (L1-) Always Below 1 Ω
I25-2 (CDR+) - U13-9 (R1+) Always Below 1 Ω
I25-3 (CDR-) - U13-10 (R1-) Always Below 1 Ω
U13-11 (SLD1) - Body ground Always Below 1 Ω
I25-4 (CDL+) - Body ground Always 10 kΩ or higher
I25-5 (CDL-) - Body ground Always 10 kΩ or higher
I25-2 (CDR+) - Body ground Always 10 kΩ or higher
I25-3 (CDR-) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR