Home › Audio / Visual / Telematics › AUDIO / VIDEO › WINDOW GLASS ANTENNA WIRE
RM27L0U _56 Audio / Visual / Telematics _049329 AUDIO / VIDEO _0235778 WINDOW GLASS ANTENNA WIRE A

AUDIO / VIDEO  WINDOW GLASS ANTENNA WIRE  REPAIR  


PROCEDURE

Hide 1.INSPECT WINDOW GLASS ANTENNA WIRE

E137056E01
1.783,2.042 2.273,2.209 0.490,0.167 10 Tin Foil 1.516,2.487 2.395,2.642 0.880,0.155 10 Antenna Wire 1.067,0.697 1.911,0.852 0.844,0.155 10 Tester Probe 2.064,1.998 2.027,1.762 false 1.475,2.558 0.878,1.968 false 1.027,0.789 0.562,1.526 false

NOTICE:

When cleaning the glass, use a soft, dry cloth, and wipe the glass in the direction of the wire. Take care not to damage the wires. Do not use detergents or glass cleaners with abrasive ingredients. When measuring voltage, wind a piece of tin foil around the top of the probe and press the foil against the wire with your finger, as shown in the illustration.


a.
E032576

Check the voltage at the center of each wire, as shown in the illustration.


Hide 2.REPAIR WINDOW GLASS ANTENNA WIRE

E137057E02
1.156,0.302 0.948,0.573 false 2.219,0.813 2.354,0.813 2.354,0.813 2.5,1.615 false 2.177,1.479 1.854,2.052 1.854,2.052 2.156,1.719 true 1.469,2.563 1.115,2.25 false 0.656,2.427 1.021,3.042 true 1.396,0.729 2.271,1.021 0.875,0.292 10 false Repair Point 1.51,2.521 2.375,2.813 0.865,0.292 10 false Broken Wire 1.323,2.063 2.292,2.375 0.969,0.313 10 false Masking Tape 1.198,0.188 2.156,0.531 0.958,0.344 10 false Fine Tip Brush 0.906,3.052 1.875,3.354 0.969,0.302 10 false Window Glass

a.

Clean the broken wire tips with grease, wax and silicone remover.


b.

Place masking tape along both sides of the wire to be repaired.


c.

Thoroughly mix the repair agent ("DuPont" paste No. 4817).


d.

Using a fine tip brush, apply a small amount of the repair agent to the wire.


e.

After a few minutes, remove the masking tape.

NOTICE:

Do not allow electricity to flow in the antenna wire for at least 24 hours.