Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049329 AUDIO / VIDEO _0235782 AUDIO AND VISUAL SYSTEM C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  B158F  AV Signal Stoppage (Low Battery Voltage)  


DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio and display receiver assembly dropping temporarily.

DTC Code DTC Detection Condition Trouble Area
B158F A video or audio signal is interrupted when the battery voltage drops. Radio and display receiver assembly

WIRING DIAGRAM

E280911E26
0.833,0.979 1.677,1.188 0.844,0.208 10 false from Battery 3.198,1.167 4.229,1.354 1.031,0.188 10 false RAD NO.1 5.073,0.896 5.198,1.083 0.125,0.188 10 false 4 5.25,0.99 5.604,1.167 0.354,0.177 10 false +B1 5.01,1.896 5.427,2.052 0.417,0.156 10 false I58 5.01,2.052 6.302,2.385 1.292,0.333 10 false Radio and Display Receiver Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.
E285959

Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>SYSTEM DESCRIPTION)]


b.

Check that the battery voltage.

Standard voltage:

11 to 14 V


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.




OK

2.CHECK FOR DTC

NG

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE)
3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE)
a.
U154168E01
1.567,0.316 1.948,0.500 0.381,0.184 10 I58 2.825,0.475 3.138,0.659 0.312,0.184 10 +B1 0.083,0.045 0.396,0.229 0.312,0.184 10 *a 2.304,0.949 2.55,0.563 2.55,0.563 2.816,0.563 false

Disconnect the radio and display receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I58-4 (+B1) - Body ground Always 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR