This circuit is used when the voice guidance in the navigation system is on or an incoming cellular phone voice in the "Bluetooth" hands-free system is heard.
Using this circuit, the navigation receiver assembly sends the signals to the stereo component amplifier assembly.
Disconnect the I27 navigation receiver assembly connector.
Disconnect the I17 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I27-2 (RL+) - I17-15 (II1+) | Always | Below 1 Ω |
| I27-6 (RL-) - I17-14 (II1-) | Always | Below 1 Ω |
| I17-18 (SLD1) - Body ground | Always | 10 kΩ or higher |
| I27-2 (RL+) - Body ground | Always | 10 kΩ or higher |
| I27-6 (RL-) - Body ground | Always | 10 kΩ or higher |
OK
(See pageAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE)
NG