Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049330 NAVIGATION / MULTI INFO DISPLAY _0235785 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the navigation receiver assembly via this circuit.

The sound signal that has been sent is amplified by the navigation receiver assembly, and then is sent to the speakers.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the navigation receiver assembly or speakers.

WIRING DIAGRAM

E283433E01
0.86,1.002 1.288,1.208 0.427,0.206 10 AUXO 0.952,1.471 1.379,1.663 0.427,0.193 10 ARO 0.987,1.939 1.414,2.237 0.427,0.298 10 ALO 0.867,2.421 1.295,2.644 0.427,0.223 10 ASGN 0.86,2.89 1.288,3.134 0.427,0.244 10 AGND 2.589,3.052 3.246,3.274 0.657,0.222 10 Shielded 4.124,3.052 4.781,3.288 0.657,0.236 10 Shielded 5.974,1.002 6.401,1.158 0.427,0.155 10 ADPG 5.974,1.485 6.401,1.640 0.427,0.155 10 VAR+ 5.707,0.892 5.888,1.047 0.181,0.155 10 25 5.707,1.379 5.888,1.535 0.181,0.155 10 26 5.707,1.846 5.888,2.001 0.181,0.155 10 28 5.707,2.327 5.888,2.482 0.181,0.155 10 27 5.707,2.793 5.888,2.949 0.181,0.155 10 11 1.402,0.906 1.681,1.061 0.278,0.155 10 9 1.402,1.388 1.583,1.544 0.181,0.155 10 6 1.402,1.857 1.583,2.012 0.181,0.155 10 7 1.402,2.298 1.583,2.453 0.181,0.155 10 8 1.402,2.808 1.676,2.964 0.274,0.155 10 10 0.45,3.357 1.401,3.512 0.951,0.155 10 I51 0.45,3.511 1.685,3.909 1.235,0.398 10 No. 1 Stereo Jack Adapter Assembly 5.685,3.525 7.026,3.878 1.341,0.353 10 Navigation Receiver Assembly 5.974,1.939 6.401,2.094 0.427,0.155 10 VAL+ 5.974,2.442 6.401,2.598 0.427,0.155 10 VA- 5.974,2.904 6.401,3.059 0.427,0.155 10 AGND 5.685,3.357 6.120,3.512 0.435,0.155 10 I53

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the I53 navigation receiver assembly connector.


b.

Disconnect the I51 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I53-25 (ADPG) - I51-9 (AUXO) Always Below 1 Ω
I53-26 (VAR+) - I51-6 (ARO) Always Below 1 Ω
I53-28 (VAL+) - I51-7 (ALO) Always Below 1 Ω
I53-27 (VA-) - I51-8 (ASGN) Always Below 1 Ω
I53-11 (AGND) - I51-10 (AGND) Always Below 1 Ω
I53-25 (ADPG) - Body ground Always 10 kΩ or higher
I53-26 (VAR+) - Body ground Always 10 kΩ or higher
I53-28 (VAL+) - Body ground Always 10 kΩ or higher
I53-27 (VA-) - Body ground Always 10 kΩ or higher
I53-11 (AGND) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR