These DTCs are stored when a malfunction occurs in the navigation antenna assembly.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15C0 | Navigation antenna error | ·
Navigation antenna assembly ·
Navigation receiver assembly |
| B15C1 | Error of the power source to the navigation antenna |
Clear the DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
No DTCs are output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Check if the navigation antenna assembly is securely connected to the navigation receiver assembly.
Navigation antenna assembly is securely connected.
OK
NG
Remove the navigation antenna assembly (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION ANTENNA>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 1a | Always | 50 to 500 Ω |
OK
NG