Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049330 NAVIGATION / MULTI INFO DISPLAY _0235785 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM

E282596E03
5.023,1.725 5.322,1.870 0.300,0.145 10 I50 5.002,1.865 6.315,2.218 1.314,0.353 10 Navigation Receiver Assembly 0.918,1.732 1.217,1.877 0.300,0.145 10 I51 0.897,1.872 2.134,2.239 1.237,0.367 10 No. 1 Stereo Jack Adapter Assembly 5.187,0.754 6.104,0.899 0.916,0.145 10 UDO- 5.005,0.649 5.193,0.794 0.187,0.145 10 2 5.173,1.279 6.090,1.424 0.916,0.145 10 UDO+ 1.587,0.698 2.052,0.843 0.465,0.145 10 UDO- 1.58,1.265 2.045,1.410 0.465,0.145 10 UDO+ 5.005,1.175 5.193,1.320 0.187,0.145 10 3 2.07,0.642 2.257,0.787 0.187,0.145 10 2 2.07,1.168 2.257,1.313 0.187,0.145 10 3

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the I50 navigation receiver assembly connector.


b.

Disconnect the I51 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I50-2 (UDO-) - I51-2 (UDO-) Always Below 1 Ω
I50-3 (UDO+) - I51-3 (UDO+) Always Below 1 Ω
I50-2 (UDO-) - Body ground Always 10 kΩ or higher
I50-3 (UDO+) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR