| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1532 | When either condition below is met:
·
Video signal (digital) is lost. ·
The stereo component tuner assembly is not connected while the ignition switch is ON or ACC. ·
Communication between the navigation receiver assembly and the stereo component tuner assembly is not possible when the engine is started. |
·
No. 1 navigation wire ·
Stereo component tuner assembly ·
Navigation receiver assembly ·
Harness or connector |
After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.
Clear the DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
No DTCs are output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Disconnect the f1 and e1 navigation receiver assembly connectors.
Disconnect the f2 and e3 stereo component tuner assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| f1-1 (USV4) - f2-1 (USV4) | Always | Below 1 Ω |
| f1-2 (US4-) - f2-2 (US4-) | Always | Below 1 Ω |
| f1-3 (US4+) - f2-3 (US4+) | Always | Below 1 Ω |
| f1-4 (UGD4) - f2-4 (UGD4) | Always | Below 1 Ω |
| f1-5 (USG4) - f2-5 (USG4) | Always | Below 1 Ω |
| e1-4 (+B2) - e3-4 (+B2) | Always | Below 1 Ω |
| e1-3 (ACC2) - e3-3 (ACC2) | Always | Below 1 Ω |
| e1-8 (GND2) - e3-8 (GND2) | Always | Below 1 Ω |
| f1-1 (USV4) - Body ground | Always | 10 kΩ or higher |
| f1-2 (US4-) - Body ground | Always | 10 kΩ or higher |
| f1-3 (US4+) - Body ground | Always | 10 kΩ or higher |
| f1-4 (UGD4) - Body ground | Always | 10 kΩ or higher |
| f1-5 (USG4) - Body ground | Always | 10 kΩ or higher |
| e1-4 (+B2) - Body ground | Always | 10 kΩ or higher |
| e1-3 (ACC2) - Body ground | Always | 10 kΩ or higher |
| e1-8 (GND2) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the No. 1 navigation wire with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>SATELLITE RADIO TUNER>REMOVAL).
Clear the DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
No DTCs are output.
OK
NG
Replace the stereo component tuner assembly with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>SATELLITE RADIO TUNER>REMOVAL).
Clear the DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
No DTCs are output.
OK
NG