The stereo component tuner assembly sends the sound data signal or image data signal from a device to the navigation receiver assembly via this circuit.
After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.
Disconnect the f1 and e1 navigation receiver assembly connectors.
Disconnect the f2 and e3 stereo component tuner assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| f1-1 (USV4) - f2-1 (USV4) | Always | Below 1 Ω |
| f1-2 (US4-) - f2-2 (US4-) | Always | Below 1 Ω |
| f1-3 (US4+) - f2-3 (US4+) | Always | Below 1 Ω |
| f1-4 (UGD4) - f2-4 (UGD4) | Always | Below 1 Ω |
| f1-5 (USG4) - f2-5 (USG4) | Always | Below 1 Ω |
| e1-4 (+B2) - e3-4 (+B2) | Always | Below 1 Ω |
| e1-3 (ACC2) - e3-3 (ACC2) | Always | Below 1 Ω |
| e1-8 (GND2) - e3-8 (GND2) | Always | Below 1 Ω |
| f1-1 (USV4) - Body ground | Always | 10 kΩ or higher |
| f1-2 (US4-) - Body ground | Always | 10 kΩ or higher |
| f1-3 (US4+) - Body ground | Always | 10 kΩ or higher |
| f1-4 (UGD4) - Body ground | Always | 10 kΩ or higher |
| f1-5 (USG4) - Body ground | Always | 10 kΩ or higher |
| e1-4 (+B2) - Body ground | Always | 10 kΩ or higher |
| e1-3 (ACC2) - Body ground | Always | 10 kΩ or higher |
| e1-8 (GND2) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the No. 1 navigation wire with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>SATELLITE RADIO TUNER>REMOVAL).
Check that the malfunction disappears.
Malfunction disappears.
OK
NG
(See pageAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE)