27330
1.INSPECT GENERATOR ROTOR ASSEMBLY
Check the rotor for an open circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Slip ring - Slip ring | 20°C (68°F) | 2.3 to 2.7 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Slip ring - Slip ring | 20°C (68°F) | 1.5 to 1.9 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Slip ring - Slip ring | 20°C (68°F) | 1.4 to 1.8 Ω |
If the result is not as specified, replace the rotor assembly.
Check if the rotor is grounded.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Slip ring - Rotor | Always | 10 kΩ or higher |
If the result is not as specified, replace the rotor assembly.
Check that the slip rings are not rough or scored.
If rough or scored, replace the rotor assembly.
Using a vernier caliper, measure the slip ring diameter.
14.2 to 14.4 mm (0.559 to 0.567 in.)
14.0 mm (0.551 in.)
If the diameter is less than the minimum, replace the rotor assembly.
27370
2.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY
Using a vernier caliper, measure the exposed brush length.
10.5 mm (0.413 in.)
4.5 mm (0.177 in.)
If the exposed length is less than the minimum, replace the brush holder assembly.
27310B
3.INSPECT GENERATOR DRIVE END FRAME BEARING
When rotating the bearing, check that there is no abnormal noise and that it rotates smoothly.
If necessary, replace the bearing.
27310B
4.REPLACE GENERATOR DRIVE END FRAME BEARING
Remove the 4 screws and retainer plate.
Using SST and a hammer, tap out the bearing.
for 130 A, 150 A Type:
Install the generator drive end frame bearing.
Using SST and a press, press in a new bearing.
Install the retainer plate with the 4 screws.
for 180 A Type:
Install the generator drive end frame bearing.
Using SST and a press, press in a new bearing.
Install the retainer plate with the 4 screws.
27330A
5.INSPECT GENERATOR ROTOR BEARING
When rotating the bearing, check that there is no abnormal noise and that it rotates smoothly.
If necessary, replace the generator rotor.