Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM
RM27L0U _57 Power Source / Network _049335 NETWORKING _0235802 CAN COMMUNICATION SYSTEM L

NETWORKING  CAN COMMUNICATION SYSTEM  PRECAUTION  


STEERING SYSTEM HANDLING PRECAUTIONS


a.

Care must be taken when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazards when driving.



SRS AIRBAG SYSTEM HANDLING PRECAUTIONS


a.

This vehicle is equipped with an SRS (Supplemental Restraint System) such as the driver airbag and front passenger airbag. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may lead to a serious accident. Before servicing (including installation/removal, inspection and replacement of parts), be sure to read the precautionary notice for the supplemental restraint system (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).



BUS LINE REPAIR


E120441

a.

After repairing the bus line with solder, wrap the repaired part with vinyl tape (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>ELECTRONIC CIRCUIT INSPECTION PROCEDURE).

NOTICE:
·

The CANL bus line and CANH bus line must be installed together.

·

When installing the CAN bus lines, twist them together.

·

CAN bus lines are likely to be influenced by noise if the bus lines are not twisted together.

·

Leave approximately 80 mm (3.15 in.) loose in the twisted wires around the connectors.




b.
E134624E02
0.625,0.492 1.502,0.659 0.876,0.167 10 Bypass Wire 1.707,0.605 1.85,0.605 1.85,0.605 2.053,1.03 false

Do not use bypass wiring between the connectors.

NOTICE:

The feature of the twisted wire harness will be lost if bypass wiring is used.




CONNECTOR HANDLING


E120443E01
0.291,1.521 1.124,1.688 0.833,0.168 10 Tester Probe 1.805,1.217 1.325,1.603 1.325,1.603 1.537,1.544 false

a.

When inserting tester probes into a connector, insert them from the rear of the connector.


b.
E120444E01
1.645,0.203 2.449,0.367 0.804,0.164 10 Repair Wire 1.448,0.893 1.625,0.348 1.625,0.348 1.528,1.263 false

Use a repair wire to check the connector if it is impossible to check resistance from the rear of the connector.