81240
1.INSPECT NO. 1 ROOM LIGHT ASSEMBLY
Connect the (+) lead from the battery to terminal 1 and the (-) lead to terminal 2 or 3.
Check that the room light comes on.
| Measurement Condition | Switch Condition | Specified Condition |
|---|---|---|
| Battery positive (+)
→ Terminal 1 Battery negative (-) → Terminal 2 |
ON | Room light comes on |
| OFF | Room light turns off | |
| Battery positive (+)
→ Terminal 1 Battery negative (-) → Terminal 3 |
ON | Room light comes on |
| OFF | Room light turns off |
If the result is not as specified, replace the No. 1 room light assembly.