Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT SWITCH
RM27L0U _58 Vehicle Interior _049338 LIGHTING (INT) _0235839 ROOM LIGHT SWITCH G

LIGHTING (INT)  ROOM LIGHT SWITCH  INSPECTION  


PROCEDURE

Hide 84170 1.INSPECT INTERIOR DOME LIGHT SWITCH ASSEMBLY

a.
E146766E02
0.198,0.082 2.678,0.451 2.480,0.369 10 Component without harness connected: (Interior Dome Light Switch Assembly) 2.748,1.406 3.063,1.562 0.316,0.156 10 ILL+ 0.324,1.402 0.626,1.565 0.302,0.163 10 ILL- 1.799,2.955 1.941,3.118 0.142,0.163 10 E 2.748,2.745 3.153,2.907 0.406,0.163 10 FCTY 0.195,2.745 0.601,2.907 0.406,0.163 10 FLMP 2.418,1.933 2.71,1.486 false 1.014,1.915 0.722,1.468 false 0.705,2.821 1.026,2.391 false 2.699,2.843 2.378,2.414 false 1.851,2.408 1.851,2.912 false

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (FCTY) - 10 (FLMP) DOOR Below 1 Ω
7 (E) - 10 (FLMP) ON Below 1 Ω


If the result is not as specified, replace the interior dome light switch.



b.

Check the illumination operation.

i.

Connect the positive (+) battery lead to terminal 1 (Ill+) and the negative (-) battery lead to terminal 4 (Ill-), and then check that the illumination illuminates.

OK:

Illumination illuminates.


If the result is not as specified, replace the interior dome light switch.