Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM27L0U _58 Vehicle Interior _049339 METER / GAUGE / DISPLAY _0235844 METER / GAUGE SYSTEM D

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  SYSTEM DESCRIPTION  


METER GAUGE AND WARNING INDICATOR



Meter/Gauge
Item Details
Speedometer Based on signal received from wheel speed sensor, skid control ECU calculates vehicle speed and transmits data to combination meter (CAN).
ODO/TRIP meter
·

Combination meter receives vehicle speed pulse integration signal from skid control ECU, and ODO/TRIP meter display operates (CAN).

·

Using ODO/TRIP switch, ODO/TRIP meter display changes.


Tachometer Combination meter receives engine rpm signal from ECM, and gauge needle operates (CAN).
Engine coolant temperature gauge Combination meter receives water temperature signal from ECM, and gauge needle operates (CAN).
Fuel receiver gauge Combination meter receives fuel amount information measured by fuel sender gauge, and gauge needle operates (Direct line).
Voltage meter Monitors IG voltage and gauge needle operates (Direct line).
Oil pressure receiver gauge Combination meter receives engine rpm signal from ECM (CAN), and receives oil pressure sender signal from oil pressure sender (Direct line). Then meter measures signals and gauge needle operates.
A/T oil temperature receiver gauge*1 Combination meter receives A/T oil temperature signal from ECM, and gauge needle operates (CAN).

*1: w/ A/T Oil Temperature Receiver Gauge


Warning/Indicator
Item Details
BEAM indicator light
E268699

Receives signal from main body ECU (CAN).
A/T OIL TEMP warning light
E342432

Warning is displayed when oil temperature is high (CAN).
SRS warning light
E268701

Receives malfunction signal from airbag sensor (CAN).
DOOR indicator light
E268709

Open door indicator comes on when signal is received from main body ECU (CAN).
Driver side seat belt warning light
E268702

Receives driver seat belt signal (Unfastened) from main body ECU (CAN).
Brake warning light*1
E323413

·

Comes on when parking brake switch is ON (CAN).

·

Brake fluid level warning switch is ON (Direct line).

·

Vehicle stability control system is malfunctioning.


Brake warning light*2
E268703

CHARGE warning light
E323422

Receives malfunction signal from generator (Direct line).
4LO indicator light*3
E344059

Receives 4LO signal from 4WD control ECU (CAN).
ABS warning light*1
E323417

Receives malfunction signal from skid control ECU (CAN).
ABS warning light*2
E268705

MIL
E323410

Receives malfunction signal from ECM (Direct line).
FUEL warning light
E273476

Receives fuel empty signal from fuel sender gauge (Direct line).
MAIN REQD indicator light*4
E345055

·

Blinks when 4500 miles have been traveled, after ODO/TRIP switch is set (Direct line).

·

Illuminates when 5000 miles have been traveled, after ODO/TRIP switch is set (Direct line).


SLIP indicator light
E273483

Receives malfunction signal from skid control ECU (CAN).
WASHER warning light*5
E342428

Warning is displayed when the washer level is low (Direct line).
4HI indicator light*3
E344870

Receives 4HI signal from 4WD control ECU (CAN).
CRUISE main indicator light
E345056

Receives CRUISE on signal or malfunction signal from ECM (CAN).
HEAD indicator light*1
E323408

Receives taillight or headlight signal from main body ECU (CAN).
TAIL indicator light*2
E273475

Receives taillight or headlight signal from main body ECU (CAN).
Turn signal indicator light (LH/RH)
E268707

Receives turn signal from FLASHER relay (Direct line).
AUTO LSD indicator light
E344871

Receives VSC OFF switch ON signal from skid control ECU (CAN).
VSC OFF indicator light
E273484

Receives VSC control off signal or VSC system fail-safe control signal from skid control ECU (CAN).
TRAC OFF indicator light
E345057

Receives VSC OFF switch ON signal from skid control ECU (CAN).
TOW HAUL indicator light*6
E344874

Receives towing indicator signal from ECM (CAN).
Tire pressure warning light
E344872

Receives low tire pressure signal from tire pressure warning ECU (Direct line).
CENTER DIFF. indicator light*3
E344057

Receives a DIFF. LOCK signal from 4WD control ECU (CAN).
EPS warning light
E323411

Receives malfunction signal from power steering ECU (CAN).
Master warning light*7
E323409

Receives warning signal from each ECU (CAN).
Height control MAN. indicator light*8
E345058

Receives a suspension control manual signal from the suspension control ECU (CAN).
Height control HI indicator light*8 Receives a suspension position HI signal from suspension control ECU (CAN).
Height control N indicator light*8 Receives a suspension position N signal from suspension control ECU (CAN).
Height control LO indicator light*8 Receives a suspension position LO signal from suspension control ECU (CAN).
A/T P shift position indicator Receives P signal from ECM (Direct line).
A/T R shift position indicator Receives R signal from ECM (Direct line).
A/T N shift position indicator Receives N signal from ECM (Direct line).
A/T D shift position indicator Receives D signal from ECM (Direct line).
A/T S shift position indicator Receives S signal from ECM (Direct line).
A/T 6 shift position indicator Receives 6 signal from ECM (CAN).
A/T 5 shift position indicator Receives 5 signal from ECM (CAN).
A/T 4 shift position indicator Receives 4 signal from ECM (CAN).
A/T 3 shift position indicator Receives 3 signal from ECM (CAN).
A/T 2 shift position indicator Receives 2 signal from ECM (CAN).
A/T 1 shift position indicator Receives 1 signal from ECM (CAN).

*1: for U.S.A.

*2: except U.S.A.

*3: for 4WD

*4: for U.S.A. without Multi-information Display

*5: w/o Multi-information Display

*6: w/ Towing Package

*7: w/ Multi-information Display

*8: w/ Air Suspension


MULTI-INFORMATION DISPLAY (w/ Multi-information display)


When the INFO switch is pressed, the multi-information display is changed between the following: cruise information display, warning display.

a.

Cruise information display:

The cruise information is displayed in the following order each time the INFO switch is pressed.

E146751

Display Outline
Average Fuel Economy
·

Value that has been calculated by combination meter, which is based on distance driven and fuel consumption volume (fuel injection signal from No. 1 cylinder).

·

This display is updated every 10 seconds.


Current Fuel Economy
·

Value that has been calculated by combination meter. When ignition switch is turned ON, combination meter calculates this value based on distance driven and fuel consumption volume (fuel injection signal from No. 1 injector).

·

This display is updated every 0.5 seconds.


Distance To Empty
·

Value that has been calculated by combination meter. When ignition switch is turned ON, combination meter calculates this value based on fuel consumption data that combination meter continuously monitors and stores in its memory, and residual fuel volume data.

·

This display is updated every km (mile).


Trip Timer
·

Calculates and displays elapsed time since engine start signal was input into combination meter.

·

This display is updated every second.


Average Speed
·

Value that has been calculated by combination meter. This calculation is based on elapsed time since engine start signal was received by combination meter and vehicle speed signal received by combination meter.

·

This display is updated every 10 seconds.




b.

Warning display:

When a warning is necessary, the warning display interrupts the multi-information display.

The master warning light may illuminate or blink and buzzer may sound depending on the item in the multi-information display.

E216591E01
3.317,3.197 4.116,3.371 0.798,0.173 10 : Illuminates 2.884,3.506 3.947,3.667 1.063,0.161 10 Buzzer: Sounds 3.317,8.064 4.116,8.237 0.798,0.173 10 : Illuminates 3.317,6.287 4.116,6.460 0.798,0.173 10 : Illuminates 2.884,8.435 3.947,8.596 1.063,0.161 10 Buzzer: Sounds 0.805,8.064 1.603,8.237 0.798,0.173 10 : Illuminates 0.372,8.435 1.435,8.596 1.063,0.161 10 Buzzer: Sounds 0.805,3.804 1.583,3.977 0.777,0.173 10 : Blinks*2 0.805,4.235 1.603,4.408 0.798,0.173 10 : Illuminates 0.372,4.606 1.685,4.767 1.313,0.161 10 Buzzer: Sounds*2 3.317,1.708 4.081,1.881 0.764,0.173 10 : Blinks*2 2.861,2.04 4.132,2.201 1.272,0.161 10 Buzzer: Sounds*2 0.805,6.06 1.485,6.233 0.680,0.173 10 : Blinks*2 0.372,6.416 1.602,6.576 1.230,0.161 10 Buzzer: Sounds*2 2.884,6.674 4.142,6.835 1.258,0.161 10 Buzzer: Sounds*2 2.884,4.669 4.072,4.830 1.188,0.161 10 Buzzer: Sounds*2 0.172,9.4 4.920,9.584 4.748,0.184 10 *2: Occurs only when the vehicle has reached a speed of 5 km/h (3 mph). 0.172,9.024 2.365,9.208 2.193,0.184 10 *1: w/ Blind Spot Monitor Sensor 5.774,4.559 6.572,4.732 0.798,0.173 10 : Illuminates 5.34,4.93 6.404,5.091 1.063,0.161 10 Buzzer: Sounds 5.774,2.77 6.572,2.944 0.798,0.173 10 : Illuminates 5.34,3.142 6.404,3.302 1.063,0.161 10 Buzzer: Sounds 5.774,6.396 6.572,6.569 0.798,0.173 10 : Illuminates 5.34,6.767 6.404,6.928 1.063,0.161 10 Buzzer: Sounds 5.054,4.263 5.273,4.470 0.218,0.207 10 *1 5.054,6.099 5.273,6.305 0.218,0.207 10 *1

Display Details
·

DRIVER'S DOOR OPEN

·

FRONT PASSENGER'S DOOR OPEN

·

LEFT REAR DOOR OPEN

·

RIGHT REAR DOOR OPEN

·

BACK DOOR OPEN


Any door is open
ENGINE COOLANT HOT Engine coolant temperature is more than 120°C (248°F)
MAINT REQD SOON Comes on approximately 7242 km (4500 miles) after engine oil is changed
PARKING BRAKE ENGAGED Parking brake is still engaged with vehicle having reached speed of 5 km/h (3 mph)
LOW WASHER FLUID Washer fluid level is low
LOW FUEL LEVEL Fuel level is low
HIGH TRANSMISSION FLUID TEMPERATURE ATF temperature is high
MAINT REQD Comes on approximately 8047 km (5000 miles) after engine oil is changed
CHECK TRANSMISSION SYSTEM Check transmission system
BSM NOT AVAILABLE* Blind spot monitor system not available
CHECK BSM SYSTEM* Check blind spot monitor system

*: w/ Blind Spot Monitor Sensor




ACCESSORY METER


a.

This system has the following functions.

i.

Clock:

When the ignition switch is turned ON or ACC, the clock display is ON.


ii.

Cruise Information:

For cruise information, four type of information (Outside temperature, average fuel economy, instant fuel economy, and distance to empty) can be displayed.

The cruise information units can be changed by using the SETUP switch.


Outside temperature → Average fuel economy → Instant fuel economy → Distance to empty.

Information Outline
Outside Temperature:
E345059

Displays outside temperature in accordance with the outside temperature sensor signal from the A/C amplifier.
Average Fuel Economy:
E345060

·

Displays a value that has been calculated by the combination meter, which is based on the distance driven and the fuel consumption volume (fuel injection signal from the No. 1 cylinder).

·

This display is updated every 0.5 seconds.


Instant Fuel Economy:
E345061

·

Displays a value that has been calculated by the combination meter. When the ignition switch is turned ON, the combination meter calculates this value based on the distance driven and the fuel consumption volume (fuel injection signal from the No. 1 injector).

·

This display is updated every 0.5 seconds.


Distance to Empty:
E345062

·

When the ignition switch is ON, displays a value that has been calculated by the combination meter (meter ECU), which is based on the following: 1) fuel consumption data that the combination meter (meter ECU) continuously monitors and stores in its memory; and 2) residual fuel volume data.

·

This display is updated every 1.6 km (1 mile).





iii.

Security Indicator Light:

·

Informs the driver of the theft deterrent system status.

·

Depending on operation of the transponder key ECU, the interior security indicator light comes on or starts blinking.



iv.

Clearance Warning Indicator:

·

Displays the location of the obstacle and the approximate distance between the vehicle and the obstacle.

·

Turns on and off according to the intuitive parking assist system status.

·

Emits an intermittent sound to inform the driver that the ECU has detected an obstacle within the prescribed ranges.