Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM27L0U _58 Vehicle Interior _049339 METER / GAUGE / DISPLAY _0235844 METER / GAUGE SYSTEM U

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream ON.


d.

Enter the following menus: Body Electrical, Powertrain or Chassis / (desired system) / Data List.


e.

According to the display on the Techstream, read the Data List.

Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Tail Cancel SW*1 TAIL cancel switch condition/ON or OFF ON: TAIL cancel switch ON
OFF: TAIL cancel switch OFF
-
ODO/TRIP Change SW Trip switch (ODO/TRIP switch) condition/ON or OFF ON: Trip switch (ODO/TRIP switch) pushed
OFF: Trip switch (ODO/TRIP switch) not pushed
-
Vehicle Speed Meter Vehicle speed/Min.: 0 (0), Max.: 255 (158) Almost same as actual vehicle speed (when driving) Unit: km/h (mph)
Engine Rpm Engine speed/Min.: 0, Max.: 12750 Idling: 650 to 750 Unit: rpm
Coolant Temperature Engine coolant temperature/Min.: 0 (-40), Max.: 127.5 (261.5) After warming up: 80 to 100 (176 to 212)
·

Unit: °C (°F)

·

If value -40 (-40): sensor circuit open

·

If value 127.5 (261.5): sensor circuit shorted


Washer Switch Washer switch/ON or OFF ON: Washer switch ON
OFF: Washer switch OFF
-
+B Voltage Value +B voltage/Min.: 0, Max.: 25.5 Below 1 to 14 Unit: V
Integrated value for Oil Maintenance Integrated value for oil maintenance warning/Min.: 0 (0), Max.: 25500 (41037) 0 (0) to 25500 (41037) Unit: mile (km)
Fuel Input Fuel sender gauge input/Min.: 0, Max.: 127.5 Fuel sender input value Unit: L
Ambient Temperature Ambient temperature/Min.: -40 (104), Max.: 87.5 (189.5) Same as outside temperature Unit: °C (°F)
Rheostat value Light control rheostat switch input/Min.: 0, Max.: 100 Light control rheostat switch is Dark (0) → Bright (100) Unit: %
Quantity of Outside Light Outside dimmer output/Min.: 0, Max.: 100 0 to 100 Unit: %
Communication ECM/Meter DTC 1 ECM communication stop history/Rec or Unrec Rec: DTC is recorded
Unrec: DTC is not recorded
-
ECM ODO (History 1) ECM odometer history/Min.: 0, Max.: 999999 With history: 0 to 999999
Without history: ffffffh
-
Communication ECM/Meter DTC 2 ECM communication stop history/Rec or Unrec Rec: DTC is recorded
Unrec: DTC is not recorded
-
ECM ODO (History 2) ECM odometer history/Min.: 0, Max.: 999999 With history: 0 to 999999
Without history: ffffffh
-
Communication ECM/Meter DTC 3 ECM communication stop history/Rec or Unrec Rec: DTC is recorded
Unrec: DTC is not recorded
-
ECM ODO (History 3) ECM odometer history/Min.: 0, Max.: 999999 With history: 0 to 999999
Without history: ffffffh
-
Communication ABS/Meter DTC 1 Skid control ECU communication stop history/Rec or Unrec Rec: DTC is recorded
Unrec: DTC is not recorded
-
ABS/VSC ODO (History 1) Skid control ECU odometer history/Min.: 0, Max.: 999999 With history: 0 to 999999
Without history: ffffffh
-
Communication ABS/Meter DTC 2 Skid control ECU communication stop history/Rec or Unrec Rec: DTC is recorded
Unrec: DTC is not recorded
-
ABS/VSC ODO (History 2) Skid control ECU odometer history/Min.: 0, Max.: 999999 With history: 0 to 999999
Without history: ffffffh
-
Communication ABS/Meter DTC 3 Skid control ECU communication stop history/Rec or Unrec Rec: DTC is recorded
Unrec: DTC is not recorded
-
ABS/VSC ODO (History 3) Skid control ECU odometer history/Min.: 0, Max.: 999999 With history: 0 to 999999
Without history: ffffffh
-
Key Remind Sound Key reminder sound/FAST, NORMAL or SLOW Displays key reminder buzzer speed setting -
Key Remind Volume Key reminder volume/LARGE, MEDIUM or SMALL Displays key reminder buzzer volume setting -
Driver Side Seatbelt Warning Buzzer Front driver side seat belt warning buzzer setting/ON or OFF ON: Front driver side seat belt warning buzzer ON setting
OFF: Front driver side seat belt warning buzzer OFF setting
-
P-Seatbelt Warning Buzzer Front passenger side seat belt warning buzzer setting/ON or OFF ON: Front passenger side seat belt warning buzzer ON setting
OFF: Front passenger side seat belt warning buzzer OFF setting
-

*1: w/ TAIL Cancel Switch


Engine
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Engine Speed Engine speed/Min.: 0, Max.: 16383 Idling: 650 to 750 Unit: rpm
Vehicle Speed Vehicle speed/Min.: 0 (0), Max.: 255 (158) Actual vehicle speed
·

Unit: km/h (mph)

·

Speed indicated on speedometer


Coolant Temp Engine coolant temperature/Min.: -40 (-40), Max.: 215 (419) After warming up: 80 to 100 (176 to 212)
·

Unit: °C (°F)

·

If value -40 (-40): sensor circuit open

·

If value 215 (419): sensor circuit shorted



ABS/VSC/TRAC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
(FL/FR/RL/RR) Wheel Speed Wheel speed sensor (FL/FR/RL/RR) reading/Min.: 0 (0), Max.: 326 (202) Actual wheel speed Similar speed as indicated on speedometer



ACTIVE TEST


HINT:

Using the Techstream to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream ON.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

According to the display on the Techstream, perform the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Speed Meter Operation*5 Speedometer 0, 40, 80, 120, 160, 200, 240 or 280 Perform the test with the vehicle stopped and the engine idling.
Acceptable range (km/h or mph): [Control range → Speedometer display]
for mph
·

40 mph → 39 to 42.5 mph

·

80 mph → 79.5 to 84 mph


for km/h
·

40 km/h → 38 to 42 km/h

·

80 km/h → 78 to 84 km/h

·

120 km/h → 119 to 125 km/h

·

160 km/h → 159 to 167 km/h


TachoMeter Operation Tachometer 0, 1000, 2000, 3000, 4000, 5000, 6000 or 7000 Perform the test with the vehicle stopped and engine idling
Fuel Meter Operation Fuel receiver gauge EMPTY, 1/2 or FULL Perform the test with the vehicle stopped and engine idling
Water Temperature Meter Operation Engine coolant temperature receiver gauge LOW, NORMAL or HIGH Perform the test with the vehicle stopped and engine idling
Volt Meter Operation Voltmeter 0, 3, 6, 9, 12, 15 or 18 Perform the test with the vehicle stopped and engine idling
Oil Pressure Meter Operation Oil pressure receiver gauge LOW, 1/4, 1/2, 3/4 or HIGH Perform the test with the vehicle stopped and engine idling
A/T Indicator Operation 1 A/T indicator (normal mode) P, R, N, D, 4, 3, 2, L Perform the test with the vehicle stopped and engine idling
A/T Indicator Operation 2 A/T indicator (sequential mode) Es, 5 or 6 Perform the test with the vehicle stopped and engine idling
Indicat. Lamp Airbag SRS warning light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. Lamp Doors All Open All doors open light ON or OFF Perform the test with the vehicle stopped and engine idling
Front Passenger Side Seat Belt Passenger side seat belt warning light ON or OFF Perform the test with the vehicle stopped and engine idling
Driver Side Seat Belt Driver side seat belt warning light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. Lamp ABS ABS warning light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. Lamp Slip SLIP indicator light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. Lamp Beam BEAM indicator light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. Lamp Head*1 HEAD indicator light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. Lamp Tail*2 TAIL indicator light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. Lamp Fuel Low fuel warning light ON or OFF Perform the test with the vehicle stopped and engine idling
VSC TRC Indicator TRAC OFF indicator light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. Tire Pressure Warning System Tire pressure warning light ON or OFF Perform the test with the vehicle stopped and engine idling
A/T Oil Temperature Operation A/T OIL TEMP warning light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. Lamp Cruise CRUISE main indicator light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. Lamp Brake Brake warning light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. EPS EPS warning light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. Oil Maintenance*3 Oil maintenance warning light ON or OFF Perform the test with the vehicle stopped and engine idling
Master Warning*4 Master warning light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. Auto LSD AUTO LSD indicator light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. Ctr DIFF LOCK CENTER DIFF. indicator light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. 4LO 4LO indicator light ON or OFF Perform the test with the vehicle stopped and engine idling
Indicat. VSC OFF VSC OFF indicator light ON or OFF Perform the test with the vehicle stopped and engine idling
Meter Display 1*6 All dots in the multi-information display ALL or OFF Perform the test with the vehicle stopped and engine idling

*1: for U.S.A.

*2: except U.S.A.

*3: w/o Multi-information Display

*4: w/ Multi-information Display


HINT:

*5:

·

It is normal that door will be locked automatically when performing the speedometer Active Test.

·

The displayed value has the same units (km/h, mph) as the main scale of the vehicle speedometer.

·

The needle position should be within the acceptable tolerance.


*6: If this Active Test is being performed and the ignition switch is turned off and then ON, the A/T and ODO/TRIP display background may turn white. If this occurs, end this Active Test and turn the ignition switch off.