Home › Vehicle Interior › MIRROR (INT) › INNER REAR VIEW MIRROR
RM27L0U _58 Vehicle Interior _049340 MIRROR (INT) _0235846 INNER REAR VIEW MIRROR D

MIRROR (INT)  INNER REAR VIEW MIRROR  CALIBRATION  


SELECT COMPASS DISPLAY MODE


a.

The compass switch allows you to select the Display or Non-display mode of the compass.



PERFORM CALIBRATION


a.

As each vehicle has its own magnetic field, calibration should be performed for each individual vehicle. This compass function is used when storing the record of the vehicle's magnetic field.



WHEN COMPASS IS MAGNETIZED


a.

A compass could be magnetized during shipping by vessels or freight cars. Therefore, make sure to perform calibration and ensure that calibration is performed properly before delivery. If this cannot be done (cannot be completed in spite of driving around several times), it may be caused by magnetization. Demagnetize the vehicle using a demagnetizer and perform calibration again.



SET COMPASS



B348466E02
2.719,0 3.958,0.198 1.24,0.198 10 false Compass Switch 5.219,0 6.115,0.177 0.896,0.177 10 false On Duration 0.615,0.385 1.844,0.75 1.229,0.365 10 false Normal Mode Ignition Switch ON 2.219,1.5 4.094,1.708 1.875,0.208 10 false Compass Non-display Mode 3.313,0.729 3.948,0.927 0.635,0.198 10 false Pressed 5.656,1.417 6.854,1.625 1.198,0.208 10 false Pressed for 6 sec. 4.563,2.854 5.844,3.073 1.281,0.219 10 false Calibration Mode 4.563,4.042 5.51,4.219 0.948,0.177 10 false Normal Mode 5.646,3.26 6.99,3.625 1.344,0.365 10 false Leaving it untouched for a while

CALIBRATION SETTING MODE


a.
B167456

Pressing the compass switch for 6 seconds in the normal mode will activate the calibration setting mode. "CAL" is displayed on the compass display.


b.

Drive the vehicle at a slow speed of 8 km/h (5 mph) or less in a circular direction.


c.

Driving in a circle 1 to 3 times will display the azimuthal direction on the display, completing the calibration.

HINT:

After the calibration is completed, it is not necessary to perform the above procedures unless the magnetic field strength is drastically changed. If this happens, the azimuthal display will be changed to "CAL".