Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235847 OCCUPANT CLASSIFICATION SYSTEM L

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION SYSTEM  PRECAUTION  


CAUTION:

Do not use seat accessories (such as cushions or covers) that cover the front seat. Also, do not modify or replace the upholstery of the front seat. Doing so may prevent the front passenger airbag system from activating correctly, disable the system or cause the front passenger airbag to inflate accidentally, and result in death or serious injury.


NOTICE:
·

Replace the occupant classification ECU, occupant detection sensor, seat cushion cover pad and seat cushion cover as a 4 part set (see supply set part No.).

·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



INSPECTION PROCEDURE FOR VEHICLE INVOLVED IN ACCIDENT


a.

Perform the zero point calibration and sensitivity check if any of the following conditions apply (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION SYSTEM>INITIALIZATION).

·

The occupant classification ECU is replaced.

·

Accessories (seatback tray and seat cover, etc.) are installed.

·

The front passenger seat is removed from the vehicle.

·

The passenger airbag ON/OFF indicator (OFF) comes on when the front passenger seat is not occupied.

·

The vehicle is brought to the workshop for repair due to an accident or a collision.


NOTICE:

When a vehicle that has been in an accident is brought into the workshop for repair, check the flatness of the floor where the front seat RH is mounted. If the flatness is not within +/-3.0 mm (0.118 in.), adjust it to the specified range.