Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235847 OCCUPANT CLASSIFICATION SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION SYSTEM  DIAGNOSIS SYSTEM  



SYMPTOM SIMULATION


HINT:

The most difficult case in troubleshooting is when no problem symptoms occur. In such a case, a thorough problem analysis must be carried out. A simulation of the same or similar conditions and environment in which the problem occurred in the customer's vehicle should be carried out. No matter how much skill or experience a technician has, troubleshooting without confirming the problem symptoms will lead to important repairs being overlooked and mistakes or delays.


a.
C353035E01
0.865,0.063 1.865,0.292 1,0.229 10 false Vibrate Slightly 0.5,2.729 2.948,2.927 2.448,0.198 10 false Shake Slightly 1.188,4.396 2.188,4.625 1,0.229 10 false Vibrate Slightly

Vibration method: When vibration seems to be the major cause.

HINT:

Perform the simulation method only during the primary check period (for approximately 6 seconds after the ignition switch is turned to ON).


i.

Slightly vibrate the part of the sensor considered to be the cause of the problem with your fingers and check whether the malfunction occurs.

HINT:

Shaking the relays too strongly may result in open relays.



ii.

Slightly shake the connector vertically and horizontally.


iii.

Slightly shake the wire harness vertically and horizontally.

The connector joint and fulcrum of the vibration are the major areas to be checked thoroughly.



b.

Simulation method for DTC B1795: Turn the ignition switch from off to ON, hold it for 10 seconds, and then turn it back to off. Repeat this procedure 50 times in a row.

HINT:

DTC B1795 is output if the occupant classification ECU receives the ignition switch lock-on-lock signal 50 times in a row when a malfunction occurs in the power circuit for the occupant classification system.




FUNCTION OF PASSENGER AIRBAG ON/OFF INDICATOR


a.

Initial check

i.

Turn the ignition switch to ON.


ii.

The passenger airbag ON/OFF indicator (ON and OFF) comes on for approximately 4 seconds, and then goes off for approximately 2 seconds.


iii.

Approximately 6 seconds after the ignition switch is turned to ON, the passenger airbag ON/OFF indicator will be ON/OFF depending on the conditions listed below.

Front Seat Passenger Passenger Airbag ON/OFF Indicator SRS Warning Light
ON Indicator OFF Indicator
Adult seated ON OFF OFF
Child seated/Child restraint system set OFF ON OFF
Vacant OFF OFF OFF
Passenger occupant classification system failure OFF ON ON

HINT:
·

The passenger airbag ON/OFF indicator operates based on the timing chart below in order to check the indicator light circuit.

·

When the occupant classification system has trouble, both the SRS warning light and the passenger airbag ON/OFF indicator (OFF) come on. In this case, check the DTCs in Airbag System first.

C353063E02
0.271,0.781 2.563,0.979 2.292,0.198 10 false Ignition Switch 1.625,0.688 1.938,0.885 0.313,0.198 10 false ON 1.615,1.063 1.927,1.26 0.313,0.198 10 false OFF 0.24,1.531 1.365,2.344 1.125,0.813 10 false Passenger Airbag ON/OFF Indicator ("ON") 1.615,1.938 1.927,2.135 0.313,0.198 10 false OFF 1.615,1.552 1.927,1.75 0.313,0.198 10 false ON 0.26,2.344 1.396,2.99 1.135,0.646 10 false Passenger Airbag ON/OFF Indicator ("OFF") 1.604,2.708 1.917,2.906 0.313,0.198 10 false OFF 1.615,2.365 1.927,2.563 0.313,0.198 10 false ON 3.031,1.167 4.406,1.365 1.375,0.198 10 false 4 Seconds 3.052,1.979 4.427,2.177 1.375,0.198 10 false 4 Seconds 4.021,1.135 5.396,1.333 1.375,0.198 10 false 2 Seconds 4,2.01 5.375,2.208 1.375,0.198 10 false 2 Seconds 4.615,3.125 6.719,3.802 2.104,0.677 10 false ON/OFF condition depends on the front passenger detection results.






CHECK PASSENGER AIRBAG ON/OFF INDICATOR


a.
E161755

Turn the ignition switch to ON.


b.

Check that the passenger airbag ON/OFF indicator (ON and OFF) comes on for approximately 4 seconds, and then goes off for approximately 2 seconds.

HINT:

Refer to the table in the previous step regarding the passenger airbag ON/OFF indicator when approximately 6 seconds have elapsed after the ignition switch is turned to ON.