Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT AIRBAG SENSOR
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235850 FRONT AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT AIRBAG SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 89174A 3.REMOVE FRONT AIRBAG SENSOR

a.
C180940E01
1.479,1.747 2.019,1.917 0.540,0.170 10 Housing 1.456,1.848 0.992,2.457 false 1.435,2.687 1.762,2.852 0.327,0.165 10 CPA 1.401,2.776 1.178,2.629 false 0.159,2.857 1.157,3.171 0.998,0.313 10 Primary Locked State

Disconnect the airbag connector.

NOTICE:
·

Do not disconnect the airbag connector by pulling the wire harness.

·

Release the lock without holding the upper side of CPA.



i.

While pushing the housing, slide only the CPA backward (from its provisionally locked state).


ii.

Detach the connector while pushing the housing in the provisionally locked state.


iii.
B106583

After detaching the connector, confirm that the CPA protrudes beyond the rear of the housing.



b.
C180938

Remove the bolt.


c.

Disengage the guide and remove the front airbag sensor.

CAUTION:

Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.