Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235851 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  INSTALLATION  


PROCEDURE

Hide 45130 1.INSTALL STEERING PAD

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Support the steering pad with one hand.


d.
B354950

Connect the 2 airbag connectors to the steering pad.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



e.

Push in the 2 connector locks to install the 2 airbag connectors.


f.

Connect the horn connector to the steering pad.


g.

Install the steering pad.


h.
B354952

Using a T30 "TORX" socket wrench, tighten the 2 screws.

Torque:
8.8 N*m (90 kgf*cm, 78 in.*lbf)


Hide 45187 2.INSTALL LOWER NO. 3 STEERING WHEEL COVER

a.
B355450

Attach the guide and claw to install the lower No. 3 steering wheel cover.


Hide 45186 3.INSTALL LOWER NO. 2 STEERING WHEEL COVER

a.
B355451

Attach the guide and claw to install the lower No. 2 steering wheel cover.


Hide 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45130 5.INSPECT STEERING PAD

a.

With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:

Cuts, small cracks or marked discoloration on the steering pad top surface or in the grooved portion.


b.

Make sure that the horn sounds.

If the horn does not sound, inspect the horn system.