Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235858 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55301 3.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

a.

Remove the instrument panel sub-assembly (See pageVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL ).


Hide 82142A 5.REMOVE NO. 2 INSTRUMENT PANEL WIRE

a.
B385260E01
2.615,0.466 2.839,0.660 0.224,0.194 10 *1 2.428,0.832 2.609,0.595 false

Using a thin-bladed screwdriver, release the connector lock and disconnect the airbag connector.

Text in Illustration
*1 Connector Lock

HINT:

Use the same procedure to disconnect the airbag connector on the other side.



b.

Detach the wire harness clamp and remove the No. 2 instrument panel wire.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



Hide 82143C 6.REMOVE NO. 3 INSTRUMENT PANEL WIRE

a.
B385261E01
2.585,0.422 2.776,0.599 0.191,0.177 10 *1 2.342,0.905 2.583,0.559 false

Using a thin-bladed screwdriver, release the connector lock and disconnect the airbag connector.

Text in Illustration
*1 Connector Lock

HINT:

Use the same procedure to disconnect the airbag connector on the other side.



b.

Detach the wire harness clamp and remove the No. 3 instrument panel wire.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



Hide 73960A 7.REMOVE FRONT PASSENGER AIRBAG ASSEMBLY

a.
B385262E01
0.192,1.479 0.372,1.647 0.180,0.168 10 *1 2.643,1.301 2.823,1.469 0.180,0.168 10 *2 2.489,1.158 2.634,1.379 false 2.645,0.093 2.826,0.261 0.180,0.168 10 *1

Remove the 2 screws.


b.

Disengage the wire harness clamp.

Text in Illustration
*1 Hook
*2 Wire Harness Clamp


c.

Disengage the 10 hooks and remove the front passenger airbag assembly.