Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Power Seat)
RM27L0U _58 Vehicle Interior _049342 SEAT _0235862 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The procedure listed below are for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 71910A 2.REMOVE FRONT SEAT HEADREST ASSEMBLY

Hide 72138E 3.REMOVE SEAT TRACK COVER INNER LH

a.

Operate the power seat switch to move the seat to the foremost position.


b.
B191067

Detach the 2 claws and remove the seat track cover.


Hide 72138D 4.REMOVE SEAT TRACK COVER LH

a.
B200255

Detach the 2 claws and remove the seat track cover.


Hide 5.REMOVE FRONT SEAT ASSEMBLY LH (w/ Leg Support Adjustment Switch)

a.

Operate the power seat switch to move the seat to the foremost position.


b.
B191041

Remove the 2 bolts.


c.

Operate the power seat switch to move the seat to the rearmost position.


d.
B194824

Remove the 2 bolts.


e.

Operate the power seat switch to move the seat to the center position.


f.
B167188

Operate the leg support adjustment switch to move the seat cushion to the open position.


g.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



h.

Disconnect the seat wire connectors under the seat.


i.

Remove the front seat.


Hide 6.REMOVE FRONT SEAT ASSEMBLY LH (w/o Leg Support Adjustment Switch)

a.

Operate the power seat switch to move the seat to the foremost position.


b.
B191041

Remove the 2 bolts.


c.

Operate the power seat switch to move the seat to the rearmost position.


d.
B194824

Remove the 2 bolts.


e.

Operate the power seat switch to move the seat to the center position.


f.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



g.

Disconnect the seat wire connectors under the seat.


h.

Remove the front seat.