Wear protective gloves. Sharp areas on the parts may injure your hands.
73590
1.REMOVE REAR NO. 2 SEAT INNER BELT ASSEMBLY LH
71692B
2.REMOVE REAR SEAT LOCK COVER OUTER LH
Remove the screw.
Detach the 2 claws and remove the rear seat lock cover outer LH.
71691C
3.REMOVE REAR SEAT LOCK COVER INNER RH
Remove the screw.
Detach the 3 claws and remove the rear seat lock cover inner RH.
4.REMOVE REAR NO. 2 SEAT CUSHION ASSEMBLY LH
Remove the 2 bolts.
Using a T45 "TORX" socket wrench, remove the 2 "TORX" bolts and 2 bushes. Then remove the rear No. 2 seat cushion assembly LH.
79370A
5.REMOVE NO. 3 SEAT CUSHION SPRING ASSEMBLY LH
Remove the hog rings.
Detach the hooks and remove the No. 3 seat cushion spring assembly LH.
79022
6.REMOVE NO. 2 SEAT CUSHION COVER SUB-ASSEMBLY LH
Remove the hog rings and No. 2 seat cushion cover sub-assembly LH from the No. 2 seat cushion pad.
72998B
7.REMOVE REAR SEAT CUSHION COVER LH
Remove the screw.
Detach the claw and remove the rear seat cushion cover LH.
72995D
8.REMOVE REAR SEAT CUSHION COVER INNER RH
Remove the screw.
Detach the claw and remove the rear seat cushion cover inner RH.
71940E
9.REMOVE REAR CENTER SEAT HEADREST ASSEMBLY
Remove the rear center seat headrest assembly.
72996D
10.REMOVE REAR NO. 2 SEATBACK COVER LH
Detach the 3 claws and remove the rear No. 2 seatback cover LH.
71702C
11.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY LH
Detach the 12 clips and remove the rear seatback board sub-assembly LH.
71970
12.REMOVE REAR SEAT HEADREST ASSEMBLY
Detach the hook and disconnect the lower part of the No. 2 seatback cover sub-assembly LH.
Remove the cable clamp and disconnect the headrest cable from the No. 3 seatback frame sub-assembly LH.
Detach the cable clamp, twist the cable end in the direction indicated by the arrow and disconnect the headrest cable from the reclining control base LH.
Using a screwdriver, push in the headrest lock button to release the headrest lock.
Tape the screwdriver tip before use.
Pull up and remove the rear seat headrest assembly.
When removing the rear seat headrest assembly while it is in the vehicle, fold down the headrest before removing it so that it does not contact the roof.
71931C
13.REMOVE REAR NO. 2 SEAT HEADREST SUPPORT ASSEMBLY
Detach the 8 claws and remove the 4 rear No. 2 seat headrest supports.
14.REMOVE SEATBACK COVER WITH PAD
Detach the 2 wire harness clamps.
Detach the hooks.
Remove the clip and rear seat belt hook.
Remove the hog ring and seatback cover with pad.
79024
15.REMOVE NO. 2 SEATBACK COVER SUB-ASSEMBLY LH
Remove the hog rings and No. 2 seatback cover sub-assembly LH from the No. 2 seatback pad.
82196
16.REMOVE REAR NO. 2 SEAT WIRE LH
Disconnect the 3 connectors.
Detach the 5 wire harness clamps and remove the rear No. 2 seat wire LH.
72572A
17.REMOVE RECLINING CONTROL BASE LH
Remove the 2 nuts and reclining control base LH.
79304A
18.REMOVE NO. 3 SEATBACK FRAME SUB-ASSEMBLY LH
Remove the 3 bolts and No. 3 seatback frame sub-assembly LH.
85820X
19.REMOVE POWER SEAT MOTOR ASSEMBLY RH
Using a screwdriver, remove the 2 washers.
Tape the screwdriver tip before use.
Using a screwdriver and hammer, lightly tap the reclining connecting pipe to remove it.
Remove the 3 bolts and power seat motor assembly RH.
85820Y
20.REMOVE POWER SEAT MOTOR ASSEMBLY LH
Remove the 3 bolts and power seat motor assembly LH.
71607
21.REMOVE REAR NO. 2 SEAT ROD SUB-ASSEMBLY
Remove the 2 bolts and No. 2 seat rod sub-assembly.