Wear protective gloves. Sharp areas on the parts may injure your hands.
71692D
1.REMOVE REAR SEAT CUSHION HINGE COVER UPPER LH
Detach the hook.
Remove the screw.
Detach the 2 claws and remove the rear seat cushion hinge cover.
71691D
2.REMOVE REAR SEAT CUSHION HINGE COVER UPPER RH
Detach the hook.
Remove the screw.
Detach the 2 claws and remove the rear seat cushion hinge cover.
3.REMOVE CENTER SEAT CUSHION ASSEMBLY
Detach the hook and loop fastener and hook.
Remove the 2 bolts.
Using a T45 "TORX" socket, remove the 2 "TORX" bolts and 2 bushes. Then remove the center seat cushion assembly.
71650
4.REMOVE REAR SEAT CUSHION SPRING ASSEMBLY
Detach the hooks and remove the rear seat cushion spring assembly.
71097S
5.REMOVE CENTER SEAT CUSHION COVER SUB-ASSEMBLY
Remove the 7 hog rings and seat cushion cover from the seat cushion pad.
71960B
6.REMOVE REAR CENTER SEAT HEADREST ASSEMBLY
71087
7.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY
Detach the 6 clips and remove the rear seatback board sub-assembly.
71396B
8.REMOVE CENTER SEAT HINGE COVER LH
Remove the screw.
Detach the 3 claws and clip and remove the center seat hinge cover.
71395B
9.REMOVE CENTER SEAT HINGE COVER RH
Remove the screw.
Detach the 3 claws and clip and remove the center seat hinge cover.
72927B
10.REMOVE REAR SEAT CUSHION UNDER COVER
Remove the 2 screws and rear seat cushion under cover.
73390A
11.REMOVE CENTER SEAT INNER BELT ASSEMBLY
73373F
12.REMOVE REAR SEAT SHOULDER BELT HOLE COVER NO. 1
Detach the 4 claws and remove the rear seat shoulder hole cover No. 1.
72667
13.REMOVE REAR SEATBACK LOCK BEZEL UPPER
Remove the center seat outer belt lower bolt.
Remove the 2 screws and rear seatback lock bezel upper.
73373F
14.REMOVE REAR SEAT SHOULDER BELT HOLE COVER NO. 2
Using a T30 "TORX" socket, remove the 2 "TORX" bolts and rear seat shoulder belt hole cover No. 2.
72615C
15.REMOVE REAR SEATBACK LOCK STRIKER COVER
Using a screwdriver, detach the claw and guide and remove the rear seatback lock striker cover.
Tape the screwdriver tip before use.
72058A
16.REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH
Remove the 2 screws.
Disconnect the cable and remove the rear seat lock control lever sub-assembly.
71931A
17.REMOVE REAR SEAT HEADREST SUPPORT
Detach the 4 claws and remove the 2 rear seat headrest supports.
73373F
18.REMOVE REAR SEAT SHOULDER BELT HOLE COVER NO. 3
Remove the 2 screws.
Detach the 2 claws and remove the rear seat shoulder belt hole cover No. 3.
19.REMOVE ARMREST ASSEMBLY
Remove the 2 nuts and armrest assembly.
72869
20.REMOVE CENTER ARMREST HINGE COVER LH
Remove the screw, slide the center armrest hinge cover LH forward to remove it, as shown in the illustration.
72868
21.REMOVE CENTER ARMREST HINGE COVER RH
Remove the screw, slide the center armrest hinge cover RH forward to remove it, as shown in the illustration.
71304C
22.REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH
Remove the bolt and rear seatback hinge sub-assembly LH.
71303C
23.REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY RH
Remove the bolt and rear seatback hinge sub-assembly RH.
24.REMOVE SEATBACK COVER WITH PAD
Remove the 5 hog rings.
Remove the 6 hog rings.
Detach the hooks.
Detach the hooks and remove the seatback cover with pad.
71095S
25.REMOVE CENTER SEATBACK COVER SUB-ASSEMBLY
Remove the center seatback cover from the center seatback pad.
73370B
26.REMOVE CENTER SEAT OUTER BELT ASSEMBLY
71398H
27.REMOVE CENTER SEAT HINGE COVER UPPER LH
Remove the screw.
Detach the 2 claws and remove the center seat hinge cover upper.
71397A
28.REMOVE CENTER SEAT HINGE COVER
Remove the screw.
Detach the 2 claws and remove the cover.
71305S
29.REMOVE CENTER SEATBACK FRAME SUB-ASSEMBLY
Remove the 2 bolts.
Using a T55 "TORX" socket, remove the 2 "TORX" bolts and center seatback frame sub-assembly.
72704A
30.REMOVE REAR SEAT RECLINING CONTROL CABLE
Detach the 2 clamps.
Rotate the cable ends and remove the rear seat reclining control cable.
Pull the cable through the center seatback frame sub-assembly.
72035
31.REMOVE REAR NO. 1 SEAT ADJUSTER SUB-ASSEMBLY
Remove the 3 nuts and rear No. 1 seat adjuster sub-assembly.
72030
32.REMOVE REAR NO. 1 SEAT ADJUSTER ASSEMBLY
Remove the 3 nuts and rear No. 1 seat adjuster assembly.
72173
33.REMOVE REAR SEAT TRACK ADJUSTING HANDLE
Slide the slide rail to the rearmost position.
Using a small screwdriver, push down the handle stopper to detach the claw and remove the adjusting handle.
Insert the screwdriver in the hole shown in the illustration, while looking into the hole.
71237
34.REMOVE REAR SEAT BRACKET
Remove the 2 nuts and rear seat bracket.