Use the same procedure for the LH side and RH side.
The procedure listed below is for the LH side.
1.INSTALL FRONT SEAT ASSEMBLY LH
Install the front seat.
Be careful not to damage the vehicle body.
Connect the seat wire connectors under the seat.
Operate the seat track adjusting handle to move the seat to the rearmost position.
Install the 2 bolts.
Operate the seat track adjusting handle to move the seat to the foremost position.
Install the 2 bolts.
72138D
2.INSTALL SEAT TRACK COVER LH
Engage the 2 claws to install the seat track cover.
72138E
3.INSTALL SEAT TRACK COVER INNER LH
Engage the 2 claws to install the seat track cover.
71910A
4.INSTALL FRONT SEAT HEADREST ASSEMBLY
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
6.INSPECT SRS WARNING LIGHT
Inspect the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).