Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Manual Seat)
RM27L0U _58 Vehicle Interior _049342 SEAT _0235876 FRONT SEAT ASSEMBLY(for Manual Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Manual Seat)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 71910A 3.REMOVE FRONT SEAT HEADREST ASSEMBLY

Hide 72138E 4.REMOVE SEAT TRACK COVER INNER LH

a.

Operate the seat track adjusting handle to move the seat to the foremost position.


b.
B191067

Disengage the 2 claws and remove the seat track cover.


Hide 72138D 5.REMOVE SEAT TRACK COVER LH

a.
B200255

Disengage the 2 claws and remove the seat track cover.


Hide 6.REMOVE FRONT SEAT ASSEMBLY LH

a.
B191041

Remove the 2 bolts.


b.

Operate the seat track adjusting handle to move the seat to the rearmost position.


c.
B191042

Remove the 2 bolts.


d.

Operate the seat track adjusting handle to move the seat to the center position.


e.

Disconnect the seat wire connectors under the seat.


f.

Remove the front seat.

NOTICE:

Be careful not to damage the vehicle body.