Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM
RM27L0U _58 Vehicle Interior _049343 SEAT BELT _0235888 SEAT BELT WARNING SYSTEM U

SEAT BELT  SEAT BELT WARNING SYSTEM  DATA LIST / ACTIVE TEST  


READ DATA LIST


HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Turn the ignition switch off.


b.

Connect the Techstream to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the Techstream on.


e.

Enter the following menus: Body Electrical / (desired system) / Data List.


f.

According to the display on the Techstream, read the Data List.

SRS Airbag
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Passenger Classification Passenger classification:
NG: Data is not determined
OFF: Vacant
Child: Child (less than 36 kg (79.37 lb)) is seated
AF05: Adult (36 to 54 kg (79.37 to 119.05 lb) is seated
AM50: Adult (more than 54 kg (119.05 lb)) is seated
Fail: A failure is detected
OFF, Child, AF05 or AM50 -
Driver Buckle SW Driver seat belt buckle switch
Unset: Driver seat belt is unfastened
Set: Driver seat belt is fastened
NG: Data is not determined
Unset or Set -
Passenger Buckle SW Front passenger seat belt buckle switch:
Unset: Front passenger seat belt is unfastened
Set: Front passenger seat belt is fastened
NG: Data is not determined
Unset or Set -

Occupant Detection
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Passenger Buckle SW Front passenger seat belt buckle switch:
Unset: Front passenger seat belt is unfastened
Set: Front passenger seat belt is fastened
NG: Data is not determined
Unset or Set -
Passenger Classification Passenger classification:
NG: Data is not determined
OFF: Vacant
Child: Child (less than 36 kg (79.37 lb)) is seated
AF05: Adult (36 to 54 kg (79.37 to 119.05 lb) is seated
AM50: Adult (more than 54 kg (119.05 lb)) is seated
Fail: A failure is detected
OFF, Child, AF05 or AM50 -

Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
P-Seatbelt Warning Buzzer Front passenger seat belt warning buzzer:
ON: Front passenger seat belt warning buzzer ON setting
OFF: Front passenger seat belt warning buzzer OFF setting
ON or OFF -



PERFORM ACTIVE TEST


HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Turn the ignition switch off.


b.

Connect the Techstream to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the Techstream on.


e.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


f.

According to the display on the Techstream, perform the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Driver Side Seat Belt Driver side seat belt warning light Driver side seat belt warning light is ON or OFF Confirm that the vehicle is stopped, engine idling
Front Passenger Side Seat Belt Front passenger side seat belt warning light Front passenger side seat belt warning light is ON or OFF Confirm that the vehicle is stopped, engine idling