1.CUSTOMIZE SEAT BELT WARNING SYSTEM
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Customizing with the Techstream
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Customize Setting / Warning.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Driver Side Seatbelt Warning Buzzer | ON | Seat belt warning buzzer ON/OFF setting | ON: Driver buzzer ON
OFF: Driver buzzer OFF |
Combination Meter |
| Front Passenger Side Seatbelt Warning Buzzer | ON | Seat belt warning buzzer ON/OFF setting | ON: Passenger buzzer ON
OFF: Passenger buzzer OFF |
When the buzzer OFF setting is selected, the buzzer activation while the vehicle is being driven is cancelled. However, the buzzer activation when the ignition switch is turned to ON cannot be cancelled.