Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM27L0U _58 Vehicle Interior _049344 HEATING / AIR CONDITIONING _0235901 AIR CONDITIONING SYSTEM J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the air conditioning amplifier.

WIRING DIAGRAM

E265176E01
0.877,0.802 2.962,1.059 2.084,0.257 10 from Battery 2.419,0.956 2.696,1.122 0.277,0.166 10 A/C 5.131,0.808 5.419,0.980 0.287,0.172 10 H24 5.179,0.616 5.372,0.775 0.193,0.159 10 21 5.138,1.336 5.412,1.502 0.274,0.166 10 H67 5.184,1.147 5.367,1.313 0.183,0.166 10 24 5.131,2.067 5.419,2.239 0.287,0.172 10 H24 5.179,1.875 5.372,2.034 0.193,0.159 10 14 5.138,2.595 5.412,2.760 0.274,0.166 10 H67 5.184,2.406 5.367,2.572 0.183,0.166 10 20 5.493,2.595 5.925,2.745 0.432,0.150 10 RGND 5.493,2.078 5.839,2.233 0.346,0.156 10 GND 5.493,1.347 5.790,1.511 0.297,0.164 10 +B2 5.493,0.821 5.709,0.995 0.216,0.174 10 B 5.313,3.132 6.328,3.439 1.015,0.308 10 Air Conditioning Amplifier

PROCEDURE

1.INSPECT FUSE (A/C)
a.
E345218E01
1.625,1.729 1.448,1.375 true 1.521,1.74 1.979,1.938 0.458,0.198 10 false A/C 0.333,0.167 2.479,0.365 2.146,0.198 10 false Main Body ECU:

Remove the A/C fuse from the main body ECU.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A/C fuse Always Below 1 Ω



c.

Reinstall the A/C fuse.



OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY, BODY GROUND)

NG

REPLACE FUSE

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY, BODY GROUND)
U153942E02
2.615,2.229 2.938,2.823 false 0.271,2.25 0.26,2.833 false 0.563,2.25 0.917,2.823 false 1.698,2.156 1.99,2.844 false 0.51,1.063 0.792,1.24 0.281,0.177 10 false H67 0.208,0.052 2.458,0.448 2.25,0.396 10 false Rear view of wire harness connector: (to Air Conditioning Amplifier) 2.917,2.833 3.135,3.01 0.219,0.177 10 false B 1.813,1.104 2.094,1.281 0.281,0.177 10 false H24 0.094,2.844 0.385,3.021 0.292,0.177 10 false +B2 0.677,2.833 1.135,2.979 0.458,0.146 10 false RGND 1.813,2.854 2.146,3 0.333,0.146 10 false GND

a.

Disconnect the H24 and H67 air conditioning amplifier connectors.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H24-14 (GND) - Body ground Always Below 1 Ω
H67-20 (RGND) - Body ground Always Below 1 Ω


Standard Voltage:
Tester Connection Condition Specified Condition
H24-21 (B) - Body ground Always 11 to 14 V
H67-24 (+B2) - Body ground Always 11 to 14 V



c.

Reconnect the air conditioning amplifier connectors.



OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR