Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM27L0U _58 Vehicle Interior _049344 HEATING / AIR CONDITIONING _0235901 AIR CONDITIONING SYSTEM J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  IG Power Source Circuit  


DESCRIPTION

When the ignition switch is turned ON, positive (+) battery voltage is applied to the air conditioning amplifier.

WIRING DIAGRAM

E146515E14
4.521,0.604 4.708,0.802 0.188,0.198 10 false 1 4.469,1.438 4.656,1.635 0.188,0.198 10 false 14 4.76,0.719 5.083,0.906 0.323,0.188 10 false IG+ 4.76,1.563 5.177,1.75 0.417,0.188 10 false GND 4.5,1.927 4.823,2.115 0.323,0.188 10 false H24 4.5,2.135 6.188,2.385 1.688,0.25 10 false Air Conditioning Amplifier 0.323,0.719 1.688,0.927 1.365,0.208 10 false from IG No. 1 Relay 2.021,0.885 2.958,1.125 0.938,0.24 10 false ECU-IG No. 1

PROCEDURE

1.INSPECT FUSE (ECU-IG NO. 1)
a.
E345206E01
2.042,1.74 2.438,1.146 true 1.646,1.781 2.521,1.969 0.875,0.188 10 false ECU-IG No. 1 0.417,0.188 2.563,0.385 2.146,0.198 10 false Main Body ECU:

Remove the ECU-IG No. 1 fuse from the main body ECU.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
ECU-IG No. 1 fuse Always Below 1 Ω



c.

Reinstall the ECU-IG No. 1 fuse.



OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY, BODY GROUND)

NG

REPLACE FUSE

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY, BODY GROUND)
E345219E01
0.594,2.271 0.979,2.521 0.385,0.25 1.969,2.854 1.708,2.146 true 2.885,2.865 2.625,2.156 true 0.521,0.208 2.781,0.646 2.26,0.438 10 false Rear view of wire harness connector: (to Air Conditioning Amplifier) 0.677,2.302 1.135,2.5 0.458,0.198 10 false H24 2.01,2.792 2.469,2.99 0.458,0.198 10 false GND 2.927,2.813 3.385,3.01 0.458,0.198 10 false IG+

a.

Disconnect the H24 air conditioning amplifier connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H24-14 (GND) - Body ground Always Below 1 Ω


Standard Voltage:
Tester Connection Switch Condition Specified Condition
H24-1 (IG+) - Body ground Ignition switch ON 11 to 14 V



c.

Reconnect the air conditioning amplifier connector.



OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR